Installation & Assembly

22
2
1
Remove the blower motor screws that holds the
blower plate to the microwave oven. Slide the plate
toward the back of the microwave and lift up to
remove.
ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
C4
Remove screw on the back of the unit.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
C3
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION
Wear safety goggles when
drilling holes in the cabinet bottom.
Wall
Mounting
Plate
Spacing for Toggles More
Than Wall Thickness
Toggle
Bolt
Toggle Wings
To use toggle bolts:
Bolt
End
Installation Instructions
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch
the bottom of the cabinet when pushed flush against
the wall and that the plate is properly centered
under the cabinet.
CAUTION
Be careful to avoid pinching
fingers between the back of the mounting plate
and the wall.
Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
3
4
Blower
Plate
Blower Motor Screws
The fan needs to be turned 180 degrees to the
right to be in the correct orientation, keeping
the blower part of the fan where the air comes
out at the top of the fan. The wire needs to be
reinsterted into the cage housing once it has been
oriented correctly.
4
Back of Microwave
Fan Blades
Wires
3
ATTACH THE MOUNTING
PLATE TO THE WALL (cont.)
C2
Screw
Carefully remove fan from cavity. Remove the wire
from the notch at the bottom of the fan after it is
removed from the cavity.
5
Remove the knockout plates in the back of the
unit with snips.
Back of microwave
Knockout Plates:
Snip all 4 webs on
each knockout panel
and remove the metal
knockouts for rear airflow.
Please take care to
remove any sharp edges
created from removing the
knockout plates.