User's Manual

10
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
CHIMNEY controls
Models with soft button keypad
HHC6.7AB
HHC9.7AB
HHC7.7AB
HHC6.7ABK
HHC6.7ABI
T1 Motor reset
Press the button with the hood off to set speed 1. Pressing
the button while the hood is in operation turns it OFF..
T2 Speed 1
Pressing the button sets the hood to speed 1.
T3 Speed 2
Pressing the button sets the hood to speed 2.
T4 Speed 3
Pressing the button sets the hood to speed 3.
T5 Booster
Pressing the button sets the hood to high speed. After 5
minutes, the hood returns to the previous speed; pressing
a speed button (T2, T3 or T4) quits booster mode and sets
the selected speed.
T6 Lights ON/OFF
Grease/odour lter warnings
The T2 icon ashes to indicate that the grease lter is
saturated, while T3 ashes to indicate that the odour lter
is saturated, and if both are ashing then both lters are
saturated. You must then clean/replace the grease lter (A)
or odour lter (B) or both, accordingly (see “Maintenance
and care”).
To reset the lter counter:
Hold down T5 for three seconds while the hood is on.
The warning led ashes three times, then returns to its
normal mode If both lter warnings are active at the same
time, you must reset each separately.
The rst sequence resets the grease lter, while the second
sequence resets the odour lter.
Hood con guration:
To set the operating mode of the hood, hold down T5 for 6
seconds while the product is off. Icons T2 or T3 will light up
to show the type of installation: T2 ventilation, T3 ltering.
You can change the type of installation by pressing T4
cyclically.
To save the new con guration press T1 individually.
Maintenance and care
Caution! Before cleaning or servicing the unit,
disconnect it from the mains by pulling the power plug
or disconnecting the main circuit breaker.
First cleaning
Remove the protective lm
Clean with a damp sponge and a little neutral soap
Rinse off with a damp cloth
Dry with a soft cloth; if the hood is stainless steel, dry
along the metal's grain
Periodic cleaning
The hood must be cleaned frequently (at least as often as
you service the grease lter), inside and out. Use a damp
cloth and a neutral liquid detergent with lukewarm water.
Do not use abrasive or corrosive products.
Warning: Failure to observe the hood cleaning and lter
cleaning/replacement instructions can result in res. Follow
the instructions carefully. The manufacturer is not liable for
any damage to the motor or res caused by incorrect care
or failure to follow the above instructions.
Servicing the grease lter (A)
A
The grease lter retains the
particles of grease produced
during cooking; it must be
cleaned at least once a month
with a non-aggressive
detergent, either by hand or
with a low temperature, short
dishwasher cycle.
To extract the grease lter,
pull the spring loaded handle.
If washed in a dishwasher, the metal lter may change
colour, but this does not affect its performance.
Servicing the charcoal lter (B)
The charcoal lter retains unpleasant cooking odours.
The lter saturates after a variable time, depending on the
type of cooking and how often the grease lter is cleaned.
The cartridge must be replaced at least once every twenty
months.
This lter can NOT be washed or regenerated
B
Disassembly: Remove the
activated-carbon filter by
pressing the two front levers
which secure it to the hood.