Istruzioni per l’uso LAVASCIUGA ! Questo simbolo ti ricorda di leggere questo libretto istruzioni.
Installazione IT ! È importante conservare questo libretto per poterlo consultare in ogni momento. In caso di vendita, di cessione o di trasloco, assicurarsi che resti insieme alla lavasciuga per informare il nuovo proprietario sul funzionamento e sui relativi avvertimenti. ! Leggere attentamente le istruzioni: ci sono importanti informazioni sull’installazione, sull’uso e sulla sicurezza. Disimballo e livellamento Disimballo 1. Disimballare la lavasciuga. 2.
Collegamento del tubo di scarico 65 - 100 cm Collegare il tubo di scarico, senza piegarlo, a una conduttura di scarico o a uno scarico a muro posti tra 65 e 100 cm da terra; Attenzione! L’azienda declina ogni responsabilità qualora queste norme non vengano rispettate. Primo ciclo di lavaggio Dopo l’installazione, prima dell’uso, effettuare un ciclo di lavaggio con detersivo e senza biancheria impostando il programma auto pulizia (vedi “Pulire la lavasciuga”).
Manutenzione e cura IT Escludere acqua e corrente elettrica Pulire la pompa • Chiudere il rubinetto dell’acqua dopo ogni lavaggio. Si limita così l’usura dell’impianto idraulico della lavasciuga e si elimina il pericolo di perdite. • Staccare la spina della corrente quando si pulisce la lavasciuga e durante i lavori di manutenzione. La macchina è dotata di una pompa autopulente che non ha bisogno di manutenzione.
Precauzioni e consigli ! La lavasciuga è stata progettata e costruita in conformità alle norme internazionali di sicurezza. Queste avvertenze sono fornite per ragioni di sicurezza e devono essere lette attentamente. Sicurezza generale • Questo apparecchio è stato concepito esclusiva- mente per un uso di tipo domestico.
Descrizione della lavasciuga IT Pannello di controllo Tasto Tasto TEMPERATURA Tasto AZIONE PULENTE BLOCCO TASTI Tasto ON/OFF DISPLAY Tasti e spie OPZIONE Cassetto dei detersivi MANOPOLA PROGRAMMI Cassetto dei detersivi: per caricare detersivi e additivi (vedi “Detersivi e biancheria”). Tasto ON/OFF : premere brevemente il tasto per accendere o spegnere la macchina. La spia START/PAUSE che lampeggia lentamente di colore verde indica che la macchina è accesa.
Display IT B A C Il display è utile per programmare la macchina e fornisce molteplici informazioni.
Come effettuare un ciclo di lavaggio e/o asciugatura IT 1. ACCENDERE LA MACCHINA. Premere il tasto ; la spia START/PAUSE lampeggerà lentamente di colore verde. 2. CARICARE LA BIANCHERIA. Aprire la porta oblò. Caricare la biancheria facendo attenzione a non superare la quantità di carico indicata nella tabella programmi della pagina seguente. 3. DOSARE IL DETERSIVO. Estrarre il cassetto e versare il detersivo nelle apposite vaschette come spiegato in “Detersivi e biancheria”. 4. CHIUDERE L’OBLO’. 5.
Programmi e opzioni Tabella dei programmi Asciugatura Prelavaggio Lavaggio Candeggina Ammorbidente Carico max. (Kg) - - 5 4,5 5 4 Cotone: Bianchi e colorati resistenti molto sporchi. 60° 1200 - 8 4 Cotone (+ prelavaggio): Bianchi estremamente sporchi. 90° 1200 - 8 5 Eco Cotone (1): Bianchi e colorati resistenti molto sporchi. 60° 1200 - - 8 5 Eco Cotone (2): Bianchi e colorati delicati poco sporchi.
Detersivi e biancheria IT Cassetto dei detersivi Il buon risultato del lavaggio dipende anche dal corretto dosaggio del detersivo: eccedendo non si lava in modo più efficace e si contribuisce a incrostare le parti interne della lavasciuga e a inquinare l’ambiente. ! Non usare detersivi per il lavaggio a mano, perché formano troppa schiuma. A B MAX 4 1 3 2 Estrarre il cassetto dei detersivi e inserire il detersivo o l’additivo come segue.
Anomalie e rimedi Può accadere che la lavasciuga non funzioni. Prima di telefonare all’Assistenza (vedi “Assistenza”), controllare che non si tratti di un problema facilmente risolvibile aiutandosi con il seguente elenco. Anomalie: Possibili cause / Soluzione: La lavasciuga non si accende. • La spina non è inserita nella presa della corrente, o non abbastanza da fare contatto. • In casa non c’è corrente. Il ciclo di lavaggio non inizia. • • • • • L’oblò non è ben chiuso.
Assistenza IT Prima di contattare l’Assistenza: • Verificare se l’anomalia può essere risolta da soli (vedi “Anomalie e rimedi”); • Riavviare il programma per controllare se l’inconveniente è stato ovviato; • In caso negativo, contattare il Numero Unico 199.199.199*. ! Non ricorrere mai a tecnici non autorizzati. Comunicare: • il tipo di anomalia; • il modello della macchina (Mod.); • il numero di serie (S/N).
Instructions for use WASHER-DRYER ! This symbol reminds you to read this instruction manual.
Installation GB ! This instruction manual should be kept in a safe place for future reference. If the washerdryer is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/herself with its operation and features. ! Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance.
Connecting the drain hose 65 - 100 cm Connect the drain hose, without bending it, to a drain duct or a wall drain situated between 65 and 100 cm from the floor; alternatively, placed it over the edge of a basin, sink or tub, fastening the duct supplied to the tap (see figure). The free end of the hose should not be underwater. ! We advise against the use of hose extensions; if it is absolutely necessary, the extension must have the same diameter as the original hose and must not exceed 150 cm in length.
Care and maintenance GB Cutting off the water and electricity supplies Caring for the door and drum of your appliance • Turn off the water tap after every wash cycle. This will limit wear on the hydraulic system inside the washer-dryer and help to prevent leaks. • Unplug the washer-dryer when cleaning it and during all maintenance work. • Always leave the porthole door ajar in order to prevent unpleasant odours from forming.
Precautions and tips ! This washer-dryer was designed and constructed in accordance with international safety regulations. The following information is provided for safety reasons and must therefore be read carefully. General safety • This appliance was designed for domestic use only.
Description of the washer-dryer GB Control panel TEMPERATURE CHILD LOCK button button ON/OFF CLEANING ACTION button button DISPLAY START/PAUSE Detergent dispenser drawer WASH CYCLE SELECTOR KNOB button and indicator light SPIN button OPTION buttons and indicator lights DRYING button Detergent dispenser drawer: used to dispense detergents and washing additives (see “Detergents and laundry”). ON/OFF button: press this briefly to switch the machine on or off.
Display GB B A C The display is useful when programming the machine and provides a great deal of information.
How to run a wash cycle or a drying cycle GB 1. SWITCH THE MACHINE ON. Press the button; the START/PAUSE indicator light will flash slowly in a green colour. 2. LOAD THE LAUNDRY. Open the porthole door. Load the laundry, making sure you do not exceed the maximum load value indicated in the table of programmes and wash cycles on the following page. 3. MEASURE OUT THE DETERGENT.
Wash cycles and options Detergents PreFabric Wash Bleach wash softener 40° 40° 60° 1200 1200 1200 - - 5 4,5 5 4 Cotton: heavily soiled whites and delicate colours. 60° 1200 - 8 4 Cotton (+ prewash): extremely soiled whites. ** 90° 1200 - 8 5 Eco Cotton (1): heavily soiled whites and delicate colours. 60° 1200 - - 8 5 Eco Cotton (2): lightly soiled whites and delicate colours.
Detergents and laundry GB Detergent dispenser drawer Successful washing results also depend on the correct dose of detergent: adding too much detergent will not necessarily result in a more efficient wash, and may in fact cause build up on the inside of your appliance and contribute to environmental pollution. ! Do not use hand washing detergents; they create too much foam. Open the detergent A B dispenser drawer and pour 4 in the detergent or washing additive, as follows.
Troubleshooting Your washer-dryer could occasionally fail to work. Before contacting the Technical Assistance Service (see “ Service”), make sure that the problem cannot be solved easily using the following list. Problem: Possible causes / Solutions: The washer-dryer does not switch • The appliance is not plugged into the socket fully, or not enough to make contact. on. • There is no power in the house. The wash cycle does not start. • • • • • The washer-dryer door is not closed properly.
Service 195130959.00 01/2015 - Xerox Fabriano GB Before contacting the Technical Assistance Service: • Check whether you can solve the problem alone (see “Troubleshooting”); • Restart the wash cycle to check whether the problem has been solved; • If this is not the case, contact an authorised Technical Assistance Centre. ! Always request the assistance of authorised technicians. Have the following information to hand: • the type of problem; • the appliance model (Mod.); • the serial number (S/N).