Operating instructions
6
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Safety Chain
! In order to prevent the appliance from overturning
DFFLGHQWDOO\IRU H[DPSOH LQFDVH RID FKLOG FOLPELQJ
onto the oven door, the safety chains MUST be installed!
The cooker is provided with safety chains that must be
¿[HGZLWKDVFUHZQRWVXSSOLHGDVDFFHVVRU\RQWKHZDOO
EHKLQGWKHDSSOLDQFHDWWKHVDPHKHLJKWDVWKH¿[LQJSRLQW
on the appliance.
0DNH VXUH WKDW WKH FKDLQV DUH ¿[HG LQ WKH EDFN RI WKH
cooker, as shown in the drawing, in such way to be tight
DQGSDUDOOHOWRWKHÀRRU
! When the installation process is complete, the chains must
be kept in tension!
Electrical connection
Those ovens equipped with a three-pole power supply cable
are designed to operate with an alternating current with the
voltage and frequency indicated on the data plate (located
on the appliance) and in the instruction manual. The wire
for earthing the appliance is yellow-green in colour.
Replacing the cable
8VHDUXEEHUFDEOHRIWKHW\SH+99)ZLWKDFURVVVHFWLRQ
of 3 x 1.5 mm². The yellow-green earth wire must be 2 ÷ 3
cm longer than the other wires.
Opening the terminal board:
8VLQJDVFUHZGULYHUSULVHRQWKHVLGHWDEVRIWKHWHUPLQDO
board cover;
3XOORSHQWKHFRYHURIWKHWHUPLQDOERDUG
To install the cable, proceed as follows:
5HPRYH WKH ZLUH FODPS VFUHZ DQG WKH WKUHH FRQWDFW
VFUHZV/1
)DVWHQWKHZLUHVEHQHDWKWKHVFUHZKHDGVXVLQJWKHIROORZLQJ
FRORXUVFKHPH%OXH1%URZQ/<HOORZ*UHHQ
)DVWHQWKHVXSSO\FDEOHLQSODFHZLWKWKHFODPSDQGFORVH
the cover of the terminal board.
NL
Connecting the supply cable to the mains
Install a standardised plug corresponding to the load indicated
on the data plate. When connecting the cable directly to the
mains, install an omnipolar circuit-breaker with a minimum
contact opening of 3 mm between the appliance and the mains.
The omnipolar circuit breaker should be sized according to the
load and should comply with current regulations (the earth wire
should not be interrupted by the circuit breaker).
The supply cable should be positioned so that it does not
reach a temperature of more than 50°C with respect to the
room temperature, anywhere along its length.
Before making the connection, check that:
7KH HOHFWULFDO VDIHW\ RI WKLV DSSOLDQFH FDQ RQO\ EH
JXDUDQWHHGLIWKHFRRNHULVFRUUHFWO\DQGHI¿FLHQWO\HDUWKHG
in compliance with regulations on electrical safety. Always
HQVXUH WKDW WKH HDUWKLQJ LV HI¿FLHQW LI \RX KDYH DQ\
GRXEWVFDOOLQDTXDOL¿HGWHFKQLFLDQWRFKHFNWKHV\VWHP
The manufacturer declines all responsibility for damage
resulting from a system which has not been earthed.
%HIRUHSOXJJLQJWKHDSSOLDQFHLQWRWKHPDLQVFKHFNWKDW
WKH VSHFL¿FDWLRQV LQGLFDWHG RQ WKH GDWH SODWH RQ WKH
appliance and/or packaging) correspond to those of the
electrical mains system of your home.
&KHFN WKDW WKH HOHFWULFDO FDSDFLW\ RI WKH V\VWHP DQG
sockets will support the maximum power of the appliance,
as indicated on the data plate. If you have any doubts,
FDOOLQDTXDOL¿HGWHFKQLFLDQ
,IWKHVRFNHWDQGDSSOLDQFHSOXJDUHQRWFRPSDWLEOHKDYH
WKHVRFNHWUHSODFHGZLWKDVXLWDEOHPRGHOE\DTXDOL¿HG
technician. The latter, in particular, will also have to
ensure that the cross section of the socket cables are
suitable for the power absorbed by the appliance. The
use of adapters, multiple sockets and/or extensions,
is not recommended. If their use cannot be avoided,
remember to use only single or multiple adapters and
extensions which comply with current safety regulations.
In these cases, never exceed the maximum current
capacity indicated on the single adapter or extension and
the maximum power indicated on the multiple adapter.
! Once the appliance has been installed, the power supply
cable and the electrical socket must be easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced by
authorised technicians only (see Assistance).
! The manufacturer declines any liability should these
safety measures not be observed.