Instruction for Use

16
OVEN MAINTENANCE AND CLEANING
IMPORTANT: When carrying out the following operations it is
advisable to wear protective gloves. Follow these instructions
carefully in order prevent injury and to avoid damaging the oven
or its hinges.
•
After every use, allow the oven to cool then clean it to prevent food
residues becoming baked on.
•
To remove any baked on food residues, use a specific oven cleaner
and follow the manufacturer's instructions on the pack.
•
Clean the outside of the oven with a sponge and warm water.
• Do not use abrasive cleaners or pan scourers.
•
Clean the glass of the door with a suitable liquid detergent.
•
Wash the accessories in a dishwasher or in the sink, using an oven
cleaner.
Important:
never clean the appliance with high pressure water or
steam cleaning equipment.
Replacing the bulb
IMPORTANT:
Disconnect the oven from the power supply.
•
To replace the oven bulb
B
, remove the protective cover
A
by
turning it anti-clockwise.
•
Replace the burnt-out bulb and fit the protective cover back in place
A
.
N.B.:
Use only 25 W, E-14 type, T 300°C bulbs, available from our
After-sales Service.
Removing the oven door
(hinges with mobile catches)
To facilitate cleaning, the oven door can be removed by operating the
hinges as shown.
The hinges
A
are equipped with two mobile catches
B
.
Lift up catch B to release the hinge from its seat. Next, lift the door
upwards and remove it by sliding it towards you; to do so, grip the door
at the sides near the hinges.
To refit the door, proceed in reverse order, first of all inserting the
hinges in their seats.
Before closing the door, remember to lower the two mobile catches B
used to hold the hinges.
Removing the inside glass of the oven door
(fig. 1-2)
To remove the inside glass of the oven door, insert a coin into the two
recesses
A
to prise the two pegs
B
from their seats (fig. 1).
Lift the glass as shown in fig. 2 and remove it from the top seat.
To reposition the glass in the door, repeat the procedure in reverse
order: reinsert the glass in its seat, resting it on the edge of the door.
Press down on the glass to fit the two pegs back into their original
position (fig. 2).
Having removed the glass, take care when cleaning the glass and
the inside edges of the door since there may be sharp parts left
by manufacturing processes.
fig. 1
fig. 2