GE AH11E/AH11H Install Manual
49-5000041 Rev. 4
Wall Thermostat Installation (Optional)
USING THE AIR CONDITIONER
Terminal Designation
)&/ )URQWGHVNFRQWUROWHUPLQDO/
)&1 )URQWGHVNFRQWUROWHUPLQDO1
/2:)$1 /RZIDQVSHHG*/
+,)$1 +LJKIDQVSHHG*+
:$<
ZD\YDOYH5HYHUVHF\FOH(QHUJL]HGLQ
+HDW)RUKHDWSXPSPRGHOV%
+($7 1RW8VHG
+($7 (OHFWULFDOKHDWHU:
&203 Compressor (Y)
91 9$&WHUPLQDO11HXWUDO&&RPPRQ
9/ 9$&WHUPLQDO/+275
IMPORTANT
2QO\WUDLQHGTXDOLILHGSHUVRQQHOVKRXOGDFFHVVHOHFWULFDO
SDQHORQXQLWDQGLQVWDOOHOHFWULFDODFFHVVRULHV3OHDVH
contact your local electrical contractor, dealer, or
distributor for assistance.
Thermostat Wire Routing
Thermostat wire is field supplied. Recommended wire
JDXJHLVWRJDXJHVROLGWKHUPRVWDWZLUH127(
,WLVUHFRPPHQGHGWKDWH[WUDZLUHVDUHUXQWRXQLWLQ
case any are damaged during installation. Thermostat
ZLUHVKRXOGDOZD\VEHURXWHGDURXQGRUXQGHU1(9(5
through, the wall sleeve. The wire should then be routed
behind the front panel to the easily accessible terminal
connector.
NOTE: Refer to thermostat installation instructions for
details on installing wall thermostat.
3RZHURIIWKHXQLW
• Turn off all dip switches by pushing them DOWN
(OFF).
)OLSWKH66DQG6GLSVZLWFKHVWRWKH8321
SRVLWLRQDVVKRZQEHORZ6HHSDJHIRUGLSVZLWFK
locations.
• Insert the wires from the wall thermostat into the correct
terminals according to manufacturers instructions.
Installation instruction for PTAC Thermostat
Remove the two screws as shown below and remove the
cover.
7KHUPRVWDW:LUH5RXWLQJ
8QGHU6OHHYH%HKLQG)URQW3DQHO
3URSHU:LUH5RXWLQJ
%HQHDWK8QLW
'LS6ZLWFK
FC(L)
FC(N)
LOW-FAN
HI-FAN
4-WAY
HEAT2
HEAT1
COMP
24V(N)
24V(L)
Terminal of PTAC Wall Thermostat (MODE A)
Remove the 2 screws
Remove the covers
Thermostat connection
terminals