Owner's Manual
6 49-5000041 Rev. 6
USING THE AIR CONDITIONER
Dip Switch Configuration
REMOVING THE FRONT PANEL
Dip switch controls are located behind front panel,
through an opening below the control panel. To
access,remove front panel.
Dip switches are accessible without opening the
FRQWUROER[
Unit must be powered OFF to change dip switch
settings.
1. 3XOORXWDWWKH
bottom to release
it from the tabs .
2. Then lift up
UP(ON)
DOWN(OFF)
1 2 3 4 1 2 3 4
S1
S9
S2
S3
S4
S5
S6
S7
S8
Heating type
Do Not Adjust
Temperature display type
Control type
Setpoint limit 1
Setpoint limit 2
Fan CON/CYC for cooling
Fan CON/CYC for heating
1 2 1 2 3 4
Low temp. Protection
'LS6ZLWFKHV
DIP SWITCHES
CONFIGURATIONS
6HHWKHWDEOHDQGILJXUHEHORZIRU'LS6ZLWFK
configurations and functions of each dip switch
position.
(Factory default switch positions (darkened portion)
shown)
No. UP (ON) DOWN (OFF) Remarks
6 (OHFWULF+HDW2QO\ (OHFWULF+HDWDQG3XPS+HDW )RU+HDW3XPSXQLWRQO\
6 Temperature Display in F° Temperature Display in C°
6 :DOO7KHUPRVWDW(QDEOH &RQWURO3DQHO(QDEOH
66
6Ÿ6Ÿ))
6Ÿ6ź))
6ź6Ÿ))
6ź6ź))
7ZRFRQILJXUDWLRQV66FRPELQHWR
select unit thermostat set point range.
6 )DQ&RQWLQXRXV5XQIRU+HDWLQJ )DQ&\FOHIRU+HDWLQJ
6 Fan Continuous Run for Cooling Fan Cycle for Cooling
6 /RZWHPS3URWHFWLRQHQDEOH /RZWHPS3URWHFWLRQGLVDEOH 2SWLRQDO
DIP SWITCH CONFIGURATION TABLE
* NOTE: 7KHPD[LPXPWHPSHUDWXUHVHWWLQJLV)LQ
FRROLQJDQG)LQKHDWLQJ
Wall Thermostat Enable
$ZDOOWKHUPRVWDWFDQEHFRQQHFWHGWRWKHXQLW,ILWLV
GLSVZLWFK6PXVWEHPRYHGWRWKH:DOO7KHUPRVWDW
(QDEOH3RVLWLRQ83EHIRUHWKHZDOOWKHUPRVWDWZLOO
control the unit. For proper wall thermostat operation,
PDNHVXUHGLSVZLWFK6LVLQWKHGRZQSRVLWLRQ
Low temp. Protection (optional)
,IXQLWVHQVHVDURRPWHPSHUDWXUHEHORZ)WKHLQGRRU
fan motor and electric strip heat will turn on and warm
the room to 40°F. The fan and heater will shut down a
short time after the temperature is satisfied.
Electric Heat Only (for heat pump unit only)
7KLVVHWWLQJLVW\SLFDOO\XVHGIRU(PHUJHQF\+HDWLQJ
Heat and Cool Fan CON/CYC Dip-switches
$OORZVWKHIDQWRRSHUDWHLQFRQWLQXRXVRUF\FOHPRGHV
while the unit is in heating and cooling mode.
CON(Continuous)
$OORZVIDQWRUXQFRQWLQXRXVO\FLUFXODWLQJDLUHYHQ
when the temperature setting has been satisfied. This
switch helps to maintain the room temperature closer
to the thermostat setting.
CYC(Cycle)
This setting allows the fan to cycle on and off with the
compressor or electric heater. The fan stops a short
time after the temperature setting is satisfied.
Setpoint Temperature Limits
3URYLGHVDUHVWULFWHGUDQJHRIWHPSHUDWXUHFRQWURO