Setup and user guide

ManualsBrandsHotpoint ManualsDishwashersADPU 201 WH

DAILY REFERENCE

GUIDE

THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.

In order to receive a more complete assistance, please

PRODUCT DESCRIPTION

APPLIANCE

Before using the appliance carefully read Health and Safety guide.

CONTROL PANEL

1. Upper rack

2. Foldable aps

3. Upper rack height adjuster

4. Upper spray arm

5. Lower rack

6. Cutlery basket

7. Lower spray arm

8. Filter Assembly

9. Salt reservoir

10. Detergent and Rinse Aid dispensers

11. Rating plate

12. Control panel

To download the Use & Care Guide, connect to

the website http://docs. whirlpool.eu, following

the procedure shown on the last page.

0000 000 00000

Service:

1011

435 6 7

1. On-O/Reset button with indicator light

2. Program selection button with indicator light

3. Half Load button with indicator light

4. Salt Rell indicator light

5. Rinse Aid Rell indicator light

6. Key to Programs

7. Indicator lights - Delay 2-4-8h

8. Delay button with indicator light

9. Tablet (Tab) button with indicator light

10. Start/Pause button with indicator light / Drain out

Summary of content (8 pages)

PAGE 1
EN DAILY REFERENCE GUIDE THANK YOU FOR BUYING A WHIRLPOOL PRODUCT. In order to receive a more complete assistance, please register your appliance on www.whirlpool.eu/register To download the Use & Care Guide, connect to the website http://docs. whirlpool.eu, following the procedure shown on the last page. Before using the appliance carefully read Health and Safety guide. PRODUCT DESCRIPTION APPLIANCE 2 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12.
PAGE 2
FIRST TIME USE SALT, RINSE AID AND DETERGENT ADVICE REGARDING THE FIRST TIME USE After installation, remove the stoppers from the racks and the retaining elastic elements from the upper rack. FILLING THE SALT RESERVOIR The use of salt prevents the formation of LIMESCALE on the dishes and on the machine’s functional components. • It is important that the salt reservoir be never empty (except when the water hardness is set to - 1 “Soft”). • It is important to set the water hardness.
PAGE 3
EN Program Drying phase PROGRAMS TABLE Available options *) Detergent Duration of Water Energy container wash cycle consumption consumption (l/cycle) (kWh/cycle) (h:min)**) H G 1. Eco 03:00 10 0.83 2. Intensive 02:30 14 1.30 3. Normal 02:00 13.5 1.10 5. Rapid 00:25 8.5 0.50 7. PreWash 00:10 4 0.01 ECO program data is measured under laboratory conditions according to European Standard EN 50242. *) Not all options can be used simultaneously.
PAGE 4
OPTIONS AND FUNCTIONS OPTIONS can be selected directly by pressing the corresponding button (see Control Panel) If an option is not compatible with the selected program (see the Programs Table), the corresponding LED flashes rapidly 3 times and beeps will sound. The option will not be enabled. HALF LOAD If there are not many dishes to be washed, a half load cycle may be used in order to save water, electricity and detergent.
PAGE 5
EN DAILY USE 1. CHECK WATER CONNECTION Check that the dishwasher is connected to the water supply and that the top is open. 2. SWITCH ON THE DISHWASHER Press the ON/OFF button. 3. LOAD THE RACKS (see Loading the Racks). 4. FILLING THE DETERGENT DISPENSER (see Programs Table). 5. CHOOSE THE PROGRAM AND CUSTOMISE THE CYCLE Select the most appropriate program in accordance with the type of crockery and its soiling level (see Programs Description) by pressing the P button.
PAGE 6
LOADING THE RACKS UPPER RACK Load delicate and light dishes: glasses, cups, saucers, low salad bowls. LOWER RACK For pots, lids, plates, salad bowls, cutlery etc.... Large plates and lids should ideally be placed at the sides to avoid interferences with the spray arm.
PAGE 7
EN CARE AND MAINTENANCE CLEANING THE FILTER ASSEMBLY CLEANING THE SPRAY ARMS Regularly clean the filter assembly so that the filters do not clog and that the waste water flows away correctly. The filter assembly consists of three filters which remove food residues from the washing water and then recirculate the water: to obtain the best washing results, you need to keep them clean. On occasions, food residue may become encrusted onto the spray arms and block the holes used to spray the water.
PAGE 8
TROUBLESHOOTING Your dishwasher may not work properly. Before contacting the Service Centre check if the problem can be solved by going through the following list. PROBLEMS POSSIBLE CAUSES SOLUTIONS The dishwasher won’t start or does not respond to commands. The appliance has not been plugged in properly. Insert the plug into the socket. Power outage. The dishwasher starts automatically when the power returns. The dishwasher door is not closed. Vigorously push the door until you hear the “click”.