Instruction for Use

GB
5
! Before operating your new appliance please read
this instruction booklet carefully. It contains important
information concerning the safe installation and operation
of the appliance.
! Please keep these operating instructions for future
reference. Make sure that the instructions are kept with
the appliance if it is sold, given away or moved.
! The appliance must be installed by a qualified
professional in accordance with the instructions provided.
! Any necessary adjustment or maintenance must be
performed after the cooker has been disconnected from
the electricity supply.
Positioning and levelling
! It is possible to install the appliance alongside
cupboards whose height does not exceed that of the
hob surface.
! Make sure that the wall in contact with the back of the
appliance is made from a non-flammable, heat-resistant
material (T 90°C).
To install the appliance correctly:
• Place it in the kitchen, the dining room or the bed-sit
(not in the bathroom).
• If the top of the hob is higher than the cupboards,
the appliance must be
installed at least 600 mm
away from them.
• If the cooker is
installed underneath a wall
cabinet, there must be a
minimum distance of 420
mm between this cabinet
and the top of the hob.
This distance should be
increased to 700 mm if the
wall cabinets are flammable (see figure).
• Do not position blinds behind the cooker or less than
200 mm away from its sides.
• Any hoods must be installed according to the
instructions listed in the relevant operating manual.
Levelling
If it is necessary to level the appliance, screw the
adjustable feet into the places provided on each corner
of the base of the cooker (see
figure).
The legs* fit into the slots on the
underside of the base of the
cooker.
Electrical connection
Fitting the power supply cable
Opening the terminal board:
• Using a screwdriver, prise on the side tabs of
the terminal board cover;
• Pull open the cover of the terminal board.
NL
To install the cable, proceed as follows:
•Remove the wire clamp screw and the three contact
screws L-N-
•Fasten the wires beneath the heads of the screws
using the following color scheme : Blue (N) Brown (L)
Yellow-Green
•Fasten the supply cable in place with the clamp and
close the cover of the terminal board.
Electrical connection
Ovens with a three-pole power supply cable are desi-
gned to operate with alternated current at the supply
frequency and voltage indicated on the data plate (at
the bottom of the oven dashboard). The earthing con-
ductor of the cable is the yellow-green conductor.
Connecting the power supply cable to the mains.
Fit a normalized plug to the cable, which corresponds
to the load indicated on the data plate; if the cooker is
connected directly to the mains, an omnipolar circuit
-breaker with a minimum opening of 3 mm between the
contacts, suitable for the load indicated and complying
with current directives, must be installed between the
appliance and the mains (the earthing wire must not
be interrupted by the circuit-breaker). The power sup-
ply cable must be positioned so that it does not exceed
room temperature by 50°C at any point of its length. Be-
fore making the connection check that:
Installation
HOOD
420
Min.
min.
650
mm. with hood
min.
700
mm. without hood
mm.
600
Min. mm.
420
Min. mm.
•the limiter valve and the home system can support ap-
pliance load (see data plate);