Instruction for Use

GB
19
Automatic cleaning using the FAST CLEAN
function
With the FAST CLEAN mode, the internal temperature of
the oven reaches 500°C. The pyrolytic cycle is activated,
burning away food and grime residues. Dirt is literally
incinerated.
Keep children away from the appliance during the
automatic cleaning cycle as surfaces may become
very hot. Particles may ignite inside the oven due to the
combustion process. There is no cause for concern: this
process is both normal and hazard-free.
Before initiating the FAST CLEAN mode:
• Remove large or coarse food residues from the
inside of the oven using a damp sponge. Do not use
detergents.
• Remove all accessories.
• Do not place tea towels or pot holders over the oven
handle.
• Turn the SELECTOR knob to the “0” position.
! If the oven is too hot, the pyrolytic cycle may not start.
Wait for the oven to cool down.
! The programme may only be started once the oven door
has been closed.
! To obtain the best results from the pyrolysis cycle, we
recommend that you do not use the hob while the process
is being carried out.
To activate the FAST CLEAN cycle press and hold the
button for approximately 4 seconds. The TIMER
KNOB may be used to select the desired cleaning level;
there are three default time settings which cannot be
modified.
1. Economy (ECO): turn the knob towards “-”. Duration
1 hour.
2. Normal (NOR): initial level. Duration 1 hour and 30
minutes.
3. Intensive (INT): turn the knob towards “+”. Duration
2 hours.
4. Press the
button to confirm.
An end time for the FAST CLEAN cycle (as for a normal
cooking cycle) may be programmed (see Programming
the automatic cleaning end time).
Safety devices
• The
icon on the display, when lit, indicates that
the oven door was automatically locked as soon as
the temperature reached a high value.
• The
icon indicates that the cleaning cycle may
be cancelled at any time by pressing the
button.
• If a malfunction occurs, the heating elements will be
switched off.
• Once the oven door has been locked, you cannot
change the duration and cycle end time settings.
Programming the automatic cleaning end time
1. Press the
button until the icon and the two digits
on the DISPLAY begin to flash.
2. Turn the TIMER KNOB towards “+” and “-” to adjust
the hour value.
3. Press the
button again until the other two digits on
the DISPLAY begin to flash.
4. Turn the TIMER KNOB towards “+” and “-” to adjust
the minute value.
5. Press the
button again to confirm.
6. When the set time has elapsed, the text END appears
on the display and a buzzer sounds.
• For example: it is 9:00 a.m. and the Economy (ECO)
FAST CLEAN level has been selected, with the default
duration of 1 hour. 12:30 is scheduled as the end time.
The programme will start automatically at 11:30 a.m.
Programming has been set when the
and buttons
are illuminated. The display shows the FAST CLEAN end
time and duration alternately.
Once the automatic cleaning cycle is over
You will have to wait until the temperature inside the
oven has cooled down sufficiently before you can open
the oven door. You will notice some white dust deposits
on the bottom and the sides of your oven; remove these
deposits with a damp sponge once the oven has cooled
down completely. Alternatively, you can make use of the
already heated oven, in which case it is not necessary to
remove the deposits, they are completely harmless and
will not affect your food in any way.