Instruction for Use

GB
13
The FlexiZONE mode
The FLEXI Zone can be used to set the power of two
„interconnected” hotplates to the same level. It can be
activated if the two hotplates are OFF, by pressing the
FLEXI ZONE button
The FLEXI ZONE can be activated while the hob is on
by pressing the FLEXI ZONE button once; the LEDs
corresponding to both linked hotplates light up.
The 2 LEDs remain lit as long as the hotplates are linked
(if FLEXI ZONE button is pressed again, the hotplates are
disconnected and are both set to power level 0).
Pressing the +, - or Max buttons for one of the two Flexi
hotplates also affects the display corresponding to the
other hotplate.
To deactivate the FLEXI ZONE, press the button .
A timer may be set for the FLEXI zone; this appears on
the display and both LEDs corresponding to the linked
hotplates light up. When the Timer button is pressed,
the two linked hotplates are treated as if they were a
single zone.
Selecting and using FLEXI ZONE
To begin using the FLEXI ZONE, press the button. To
set the power level (see above).
FLEXI ZONE operation
Once you have selected FLEXI ZONE by pressing the
button , the 2 LEDs corresponding to the FLEXI ZONE
for both hotplates light up; it will then be possible to
control both as if they were a single zone. The power level
will appear on both displays. If only the upper or lower
part is in use, the display corresponding to the unused
zone will begin to flash, and after 3 minutes cooking will
automatically revert to standard mode (not FLEXI).
! Once activated, the FLEXI ZONE can also be
programmed, using the same procedure as described
for the individual hotplates.
! Accessories
For optimal FLEXI ZONE performance, we recommend
the use of pans with an elliptical or elongated base and
a major diameter of at least 250 mm; if using pans with
a smaller diameter, we recommend positioning them in
the upper or lower part as indicated by the X symbol.
If the saucepan is not in the centre of the screen printing
detail, you may hear a whistling sound or a slight buzzing
noise; this does not indicate a hob malfunction. We
recommend adjusting the position of the pan so that it is
in the centre of the FLEXI ZONE.
Practical advice on using the appliance
! Use cookware made from materials which are
compatible with the induction principle (ferromagnetic
material). We especially recommend pans made from:
cast iron, coated steel or special stainless steel adapted
for induction. Use a magnet to test the compatibility of
the cookware.
*
SUITABLE
UNSUITABLE
Cast iron
Enamelled steel
Special stainless steel
Copper,
Aluminium, Glass, Earthenware,
Ceramic, non magnetic Stainless steel
In addition, to obtain the best results from your hob:
• Use pans with a thick, flat base in order to fully utilise
the cooking zone.
• Always use pans with a diameter which is large
enough to cover the hotplate fully, in order to use all
the available heat.
• Make sure that the base of the cookware is always
clean and dry, in order to fully utilise and extend the
life of both the cooking zones and the cookware.
• Avoid using the same cookware which has been used
on gas burners: the heat concentration on gas burners
may distort the base of the pan, causing it not to adhere
correctly.
Safety devices
Pan sensor
Each cooking zone is equipped with a pan sensor device.
The hotplate only emits heat when a pan with suitable
measurements for the cooking zone is placed on it. If the
indicator light is flashing, it may indicate:
• An incompatible pan
• A pan whose diameter is too small
• The pan has been removed from the hotplate.