Setup and user guide

10
EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
• Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with
a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove any
deposits or stains caused by food residues To dry any
condensation that has formed as a result of cooking
foods with a high water content, let the oven to cool
completely and then wipe it with a cloth or sponge.
• Clean the glass in the door with a suitable liquid
detergent.
• The oven door can be removed to facilitate cleaning.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
Make sure that the oven has
cooled down before carrying out
any maintenance or cleaning.
Do not use steam cleaners.
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
Wear protective gloves.
The oven must be disconnected
from the mains before carrying
out any kind of maintenance
work.
MAINTENANCE AND
CLEANING
Download the Use and Care Guide from
docs.hotpoint.eu for more information
WWW
REPLACING THE LIGHT
1. Disconnect the oven from the power supply.
2. Unscrew the cover from the light, replace the bulb
and screw the cover back on the light.
3. Reconnect the oven to the power supply.
Please note: Only use 20-40 W/230~V type G9, T300°C
halogen bulbs. The bulb used in the product is specically
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009). Light bulbs are available from our After-sales
Service.
- If using halogen bulbs, do not handle them with your bare
hands as your ngerprints could cause damage. Do not use
the oven until the light cover has been retted.
This function enables you to eliminate cooking
spatters using a temperature of approx. 500 °C. At this
temperature, food residues turn into deposits that can
be easily wiped away with a damp sponge once the
oven has cooled down.
If the oven is installed below a hob, make sure that
all the burners or electric hotplates are switched off
while running the self-cleaning cycle.
For optimum cleaning results, remove the worst
soiling with a damp sponge before using the Pyro
function.
Do not touch the oven during the Pyro cycle.
Remove all accessories from the oven before
running the Pyro cycle.
Keep children and animals away from the oven
during and after (until the room has finished
airing) running the Pyro cycle.
CLEANING THE COOKING COMPARTMENT WITH THE PYRO CYCLE
The oven has two different pyrolytic cleaning
functions: The standard cycle (PYRO) provides
thorough cleaning if the oven is heavily soiled, while
the economic cycle (ECO) is shorter and consumes
less energy than the standard cycle, which makes it
suitable for use at regular intervals.
Only run the Pyro function if the appliance contains
heavy soiling or gives off bad odours during cooking.
Please note: The oven door cannot be opened while
pyrolytic cleaning is in progress. It will remain locked until
the temperature has returned to an acceptable level. Air the
room during and after running the Pyro cycle.