Hotec UHF Wireless Headset/Lavalier Microphone System USER MANUAL Model: H-U05/H-U25 H-U25 H-U05 Thanks for purchasing Hotec Wireless Headset/Lavalier Microphone System, please read the following instructions carefully before use. Email: support@sz-tecson.com Website: www.sz-tecson.com Facebook page: https://www.facebook.com/Hotechome/ Or scan the QR code Hotec® is the registered trademark of Shenzhen Tecson Trade and Technology Co., Ltd.
Product Introduction Hotec UHF Wireless Lapel/Lavalier and Headset Microphone system is designed for amplifying voice through speakers, karaoke machines, amplifiers, mixers for DJ, church, wedding, lecturers where hands free are needed, or for recording on phones, cameras, tablets, computers or live performances. Both the mini receiver and the bodypack transmitters are powered by rechargeable batteries. Made of aluminum zinc, the product is light weight, sturdy and small.
channel A is connected, it is Green; when Channel B is connected, it is Blue; when both channel A and channel B are connected, it is green-blue. ⑤ Charging Status indicator: This will be Red during charging. When the battery is fully charged, it turns into Green. Unplug the charger when the battery is fully charged.
Unplug the charger after the battery is fully charged. Preparation before use 1. Charge the mini receiver and transmitter(s). Charging time is about 2 hours. 2. Choose the right microphone and screw it into the mic hole of the transmitter. Make sure it is plugged in tightly. 3. Make sure the receiver and bodypack transmitter is connected. You can tell by the AF/RF indicator color. For H-U05, when you speak into the microphone, the AF/RF indicator flashes Green.
Note 2: If you would like to sing karaoke on phone or monitor the recording, connect the headphone splitter (NOT included in the box) with your phone. Plug the TS to TRRS cable to the mic jack of the headphone splitter and the headphone into the headphone jack. See Figure 3. Figure 3 3. Connect to camera with mic input (See Figure 4) Step 1: Please make sure your camera has mic input. Step 2: Connect the TS to TRS adapter to the mini receiver.
Figure 5 Figure 6 Note: The computer recognizes the microphone automatically after the receiver is connected correctly as shown above. If not, go to Control Panel/Sound/Recording, click the external microphone and go to Configuration. If you need any assistance in setting up, please contact Hotec customer service. Product Specification SYSTEM SPECIFICATIONS Modulation mode Frequency Range Preset Frequencies Frequency Response Max. Deviation Range T.H.
MINI RECEIVER Product Dimension Power Supply Power Consumption Working Hour 1.66 * 1.22 * 0.
Common issues Possible Cause Solutions My product does not work with iPhone This product works with iPhone perfectly. First, please make sure the product actually pairs with each other; then check the connections and make sure every part is connected tightly. Try to plug and unplug a few times if possible. If you are using it with a third party Apps, please check if there is any need to select the external microphone. Contact Hotec customer services if you need any assistance.