HRM5072 User Manual Bluetooth low energy beacon "HRM5072" has multi patch antenna for directivity. It works with four size AA batteries more than three years. It also supports various RF power settings (-20dBm ~ +4dBm, 4dBm step). Operating manual ①Reverse HRM5072 (The following photograph is top view.) ②Slide the bottom cover ③Attach bottom cover to the ceiling or the wall with M4 screws.
④Set four size AA batteries. HRM5072’ mode changes to the Connectable Mode for 3 minutes after battery setting. ⑤Connected to HRM5072 by the application of the smart phone and set the RF output power. (+4dBm, 0dBm, -4dBm, -8dBm, -12dBm, -16dBm, -20dBm) ⑥Attach HRM5072 to the bottom cover. ⑦ After 3 minutes from battery setting, HRM5072' mode changes to the Beacon Mode. A smart phone can get the information from HRM5072 with beacon.
FCC/IC certification number FCC ID:VIYHRM5072 IC ID:7305A-HRM5072 Certificate number is marked in the following red frame area. If the bottom cover is taken off, user can easily access certificate number.
Federal Communication Commission Interference Statement FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Part 15 Subpart B Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
FCC Part15 and IC RSS-Gen This device complies with part 15 of FCC Rules and Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme à la partie 15 des règles de la FCC et aux normes des CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
Industry Canada Statement RSS-Gen This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.