User's Manual

ManualsBrandsHosiden ManualsElectronicsBluetooth Low Energy Module

User manual

Product: Bluetooth Low Energy module

Model: HRM1062

For OEM integration only – device cannot be sold to general public.

Therefore we will not supply the User’s manual, the installation manual is the official for OEM.

FCC ID: VIYHRM1062

IC: 7305A-HRM1062

■Operational Information

This module has been tested and found to comply with the limits for a Class B digital device

pursuant to Part15 of FCC rules. This module complies with Part15 subpart C of the FCC

rules. Customers should check Part15 subpart B compliance with their own final products

and conduct certification if needed.

■Caution

Any changes or modifications are not expressly approved by Hosiden responsible for

compliance could void the user’s authority to operate the equipment.

■Requirement of Labeling

Please describe the following item on the final product including this module:

■Requirement of User’s Manual Statement

“This transmitter must not be co-located or operated in conjunction with any other antenna

or transmitter.”

Contains Transmitter Module FCC ID: VIYHRM1062 Contains FCC ID: VIYHRM1062

Contains Transmitter Module IC: 7305A-HRM1062 Contains IC: 7305A-HRM1062

Summary of content (7 pages)

PAGE 1
User manual Product: Bluetooth Low Energy module Model: HRM1062 For OEM integration only – device cannot be sold to general public. Therefore we will not supply the User’s manual, the installation manual is the official for OEM. FCC ID: VIYHRM1062 IC: 7305A-HRM1062 ■Operational Information This module has been tested and found to comply with the limits for a Class B digital device pursuant to Part15 of FCC rules. This module complies with Part15 subpart C of the FCC rules.
PAGE 2
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 3
This device is intended only for OEM integrators under the following conditions: 1) The transmitter module may not be co-located with any other transmitter or antenna. As long as 1 condition above are met, further transmitter test will not be required.
PAGE 4
Industry Canada Statement This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
PAGE 5
This device is intended only for OEM integrators under the following conditions: (For module device use) 1) The transmitter module may not be co-located with any other transmitter or antenna. As long as 1 condition above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed.
PAGE 6
End Product Labeling The final end product must be labeled in a visible area with the following: “Contains IC: 7305A-HRM1062”. Plaque signalétique du produit final Le produit final doit être étiqueté dans un endroit visible avec linscription suivante: "Contient des IC: 7305A-HRM1062".
PAGE 7
Product Specification 1. BLUETOOTH SPECIFICATIONS BT core spec version: version 5.0 Supported profiles: GATT and Original profile Operation channels: 2,402 + 2N MHz (N=0,1,2,…39, 2MHz step) RX Sensitivity: -96dBm (1Mbps, <=37bytes, BER=1E-3) 2. RADIO SPECIFICATIONS Frequency range: 2,360MHz - 2,500MHz Operation frequency range: 2,402MHz – 2,480MHz Modulation: GFSK Max tuneup tolerance: +5.64dBm MAX (e.i.r.p) (Spread spectrum is not used.