Manualshelf

Owner manual

ManualsBrandsHornady ManualsToolsLock-N-Load
1
Lock-N-Load
®
Bench Scale
The Hornady Lock-N-Load
®
Bench Scale is a precision bench scale for the beginning or serious reloader. This unit is
quick to setup, easy to use, and extremely accurate to 0.1 grains. Highlights include the same high precision load cell
found in the Lock-N-Load
®
Auto Charge
TM
, 1500 grain scale capacity, quick setup and calibration, and a large and easy to
read backlight display.
WARNING - Before operating the unit please carefully read and understand the instructions. Contact Hornady
Customer Service at 1-800-338-3220 with question regarding the use of the Lock-N-Load
®
Bench Scale.
A. TIPS TO IMPROVE PERFORMANCE
1) Fluctuation in temperature, even a couple of degrees, can cause scale readings to vary. While the scale can be
used right away, optimal performance will occur after unit has warmed up for 5-15 minutes.
2) Always place the scale on a flat, level, and stable surface when in operation.
3) Electrical interference can cause scale readings to vary. Keep other electronic devices (power strips, motors,
radios, phones, etc.) away from scale when in operation.
4) Do not let a fan, AC, heater, or open window blow on scale.
5) Use of the clear cover over the powder pan will improve accuracy, and lessen the effects of outside variables.
B. KEYPAD BUTTON FUNCTIONS
1) ON/ OFF Press to turn on. Hold for three seconds to turn off.
2)
ZERO Press to zero the scale.
3)
UNITS Press to select measurements in grains (GN), grams (GR), ounces (OZ) or CARAT (CT).
4)
CAL Press to begin calibrating scale. See Calibration, Section C.
C. CALIBRATION
1) For optimal performance, turn unit on and allow 5-15 minutes to warm up.
2) Press CAL button once and unit will display
" 0.00g ".
3) Verify the red scale plate is empty.
4) Press CAL button and the unit will then calibrate while displaying "
==== ".
5) When "
10.00g " is displayed, place the 10g weight on the center of the scale plate and press CAL. The unit will
then continue calibrating while displaying "
==== ".
6) When "
50.00g " is displayed, remove the 10g weight, and then place the 50g weight on the center of the scale
plate.
7) Press CAL. The unit will then finish calibrating while displaying "
==== ".
8) After calibrating, the unit will briefly display
“ PASS ” before returning to normal operation.
WARRANTY
The Hornady Lock-N-Load
®
Bench Scale is a highly sensitive instrument, which must be repaired and serviced by a
factory qualified technician to maintain the warranty.
Hornady Manufacturing warrants to you that for one year from the date of purchase, your Lock-N-Load
®
Bench Scale will
be free from defects in material and workmanship. This warranty does not cover damage caused by normal wear,
accidents, abuse, or failure to provide proper care and maintenance. Please contact Hornady Mfg at 1-800-338-3220 for
service or warranty information.
The warranty is void if the seal on bottom of unit has been tampered with.
11‐2010

Summary of content (1 pages)