SilentDrive series Instructions for installation and operation Radio keypad FCT3b for a garage door operator
05.
Protected by copyright. Subject to technical modifications. Any reprints, in whole or in part, are not permitted without prior written approval. All terms subject to change. English.................................................... 4 FCC ID: PZI-315FCT3B IC: 4205A-315FCT3B 05.
ENGLISH USA: FCC ID: PZI-315FCT3B Canada: IC: 4205A-315FCT3B Nevertheless, the FCT3b operating frequencies 315 MHz shall be used in such a manner that the potential for human contact during normal operation is minimized. This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. IC: before the equipment certification number signifies that the Industry Canada technical specifications were met.
ENGLISH Important Information Read and follow these instructions carefully. They provide important information for the safe installation and operation of your FCT3b. Please also follow the instructions to ensure safe operation of the operator and door. • • To ensure proper operation, all equipment should be protected from direct sunlight, moisture or dirt. The FCT3b has a temperature tolerance from -4 °F to +140 °F.
ENGLISH 1 2 3 4 5 5.1 5.2 5.3 5.4 6 Fig. 1 Fig. 2 Fig. 3 General Installation Important terminology Signals of the LED Normal Operation Transmitting after entering an access code Altering of access codes Function of the “bell/light” button Transmitting using the “bell/light” button Resetting the FCT3b to factory settings Installing the FCT3b Signals of the LED Programming/altering of access codes 1 General The FCT3b is a combination of a transmitter and a keypad.
ENGLISH 3 Important terminology Access codes These are 4-digit freely selectable unique codes, enabling you to access the three radio codes 1 to 3. An access code is always assigned to a specific radio code. In the factory setting or after a reset the access codes are: Access code for radio code 1: “1234” Access code for radio code 2: “2345” Access code for radio code 3: “3456” The fourth is the “bell/light” button which does not require an access code.
ENGLISH This is acknowledged with a long LED signal. You may now enter another access code to activate another function without waiting for the 20 seconds to expire. 5.2 Altering of access codes From the factory or after a reset all 3 storage spaces are preprogrammed with an access code. The factory codes are “1234” for radio code 1, “2345” for radio code 2 and “3456” for radio code 3. To program your own access code do as follows (see Fig. 3): 1.
Fig. 1 1/8 ” 05.
Fig. 2 2a 2b 2c Fig. 3 1x 2x Access Code 1 Access Code 2 t 3x 5 5 6 Access Code 3 1x t t 4x t 2d 1x t Access Code 1 2e t Access Code 2 Access Code 3 10 05.
05.
05.