Quick Start Guide

Horizon 2100 Series
CBRS Outdoor Routers
Quick Start Guide
Introduction
Our Horizon 2100 product series are a highly advanced LTE outdoor
multi-service solution designed to meet integrated data needs of
residential, business and enterprise users. The product supports
advanced Gigabit networking functionalities, it enables wide
service coverage and provides high data throughput and
networking features to customers who needs easy broadband
access.
Panel of device
1
· I/O panel of Outdoor Router ·
Packing List
Make sure you have everything you need to properly configure the
device.
Outdoor Router PoE Ethernet cablePower supply
Stainless steel
clamp
Cable glands Slotted end cap
2
How does it work
1. Connect Power Adapter to PoE injector.
2. PoE injector provide the power to Outdoor Router via LAN cable.
3. Connect LAN cable from PoE to your PC our Indoor router to surf
the Internet when the Outdoor Router access the LTE network.
This quick installation guide shows you how to configure your
Outdoor Router in order to access the Internet.
Configure hardware
Please make sure that you are familiar with all accident prevention
and safety procedures necessary for working at height and with
electricity before start to intall the device.
DO NOT install the Outdoor Router during a lightning storm.
CAUTION
Insert a SIM Card to the Slot
Make sure the Outdoor Router is turned off before you insert your
SIM card. It is recommended to NOT connect the PoE cable when
you do this step. Otherwise, the SIM card may be damaged.
CAUTION
3
Step 1 CAT5e cable to thread through the cable glands.
Step 2 Connect the end of the CAT5e Ethernet cable to the PoE port
of the Outdoor Router.
Step 3 Wring the cable glands into Outdoor Router and seal tightly.
NOTE: Make sure you have inserted the SIM card into the Outdoor
Router.
Mount the Outdoor Router
See the installation instructions to mount the Outdoor Router
correctly.
Header Connection
4
Mounting Bracket
The Outdoor Router can be mounted on an antenna pole or mast or
on a wall using the supplied mounting bracket.
· Choose a mounting point that is sturdy enough to hold the Outdoor
Router, even during high winds.
· When choosing a location to install the Outdoor Router, please be
noted that the Outdoor Router’s front panel should point towards
your service provider’s nearest base station. You do not need to be
able to see the base station from the Outdoor Router’s position.
However, if you experience difficulties with signal reception, a Line
of Sight (LoS) connection may produce better results.
· It is suggested that you transport the Outdoor Router to its
intended installation location in its original protective package.
To obtain the best radio signal level and connection quality, the
Outdoor Router antenna should be aimed towards the best eNB or
BS directly.To search for the best eNB direction, the user can rotate
the Outdoor Router slowly and tilte Outdoor Router slightly to find
the best signal direction. The Outdoor Router radio signal strength
level can be observed from the RF LEDs mounted on the lower
panel as shown below. The more LEDs on, the better the signal
strength.
Choose Location
5
Connect the PoE
Place a CAT5e Ethernet cable (not included) from the location of
your intended Router to the desired PC location.
If you intend to use cable clamps or other methods to secure the
cable, do not tighten them until you finish installing the Router and
Outdoor Router.
6
To connect the CAT5e Ethernet cable:
Step 1 Connect the CAT5e Ethernet cable to PoE.
Do not connect a computer or switch directly to the PoE port due to
high PoE power.
CAUTION
Step 2 Connect the power adapter to the PoE injector. The POWER
LED turns on a solid green-yellow once connected.
Step 3 Connect the included Ethernet cable from the computer or
indoor router to one of the Outdoor Router's Ethernet ports.
LED Behavior
When set up the Outdoor Unit, the LED will have the following
behavior.