Installation & Assembly

1/2

ASSEMBLY INSTRUCTION

Item#:5199-30310 desk chair (one per carton)

** Please make sure you have all parts indicated below prior to assembly.

Assembly Steps:

1. Place back frame (E) on a clean surface.

2. Tighten seat frame(F) to back legs of frame(E) by using bolt(C), lock washer(B) and flat washer(A)

at the center location (see diagram 1). Using bolts (G), lock washers (B) and flat washers (A),

tighten the corners of seat frame (F) to back legs of frame (E). (See diagram 2)

3. Install front legs (H) onto seat frame (F) using bolts (G), lock washers (B) and flat washers (A).

Tighten all bolts by hand. (See diagram 2)

4. After all bolts are attached and hand tightened, turn the chair upright.

5. Level the chair following the “chair leveling instruction” as below.

6. Make sure the chair is level and then tighten all bolts completely by using the allen wrench (D).

DIAGRAM 1

DIAGRAM 2

PAGE 1
ASSEMBLY INSTRUCTION Item#:5199-30310 desk chair (one per carton) ** Please make sure you have all parts indicated below prior to assembly. Assembly Steps: 1. Place back frame (E) on a clean surface. 2. Tighten seat frame(F) to back legs of frame(E) by using bolt(C), lock washer(B) and flat washer(A) at the center location (see diagram 1). Using bolts (G), lock washers (B) and flat washers (A), tighten the corners of seat frame (F) to back legs of frame (E). (See diagram 2) DIAGRAM 1 DIAGRAM 2 3.
PAGE 2
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE CHAIRS CHAIR LEVELING INSTRUCTION SUPPLEMENT Chair leveling procedures: To make the assembly process easy and efficient, please read the entire instruction sheet prior to assembling of the chair. Make sure all hardware listed is included. To properly assemble the chair, none of the bolts should be fully tightened until all components are attached to the chair. This will allow an opportunity to level the chair and prevent any unnecessary “rocking”. 1.