User's Manual

OPERATION INSTRUCTION

①

②

③

④

⑤

Transmitter

Screw

Front

Back

4.Light on/off:

Tap light key (See Fig.1-⑤) to control lignt on/off .

Install the transmitter wall bracket in wall by

two screws and hang transmitter in it carefully.

(See fig.3)

Wall Bracket

Open the battery housing

cover and install a 12V

battery (included)inside.

1. Pairing:

2.Fan 3 speeds：

Tap key ①/②/③（See Fig.1) to control fan

high/medium/low speed.

3.Fan on/off ：

Tap Fan on/off key(See Fig.1-④) to control fan on/off.

6 Off Memory :

When power is off and back again, resume the status of

both light and fan before switch off.

.Power

5.Light Delay Off Feature:

Press and hold fan off key(See Fig.1-④) for 5 seconds

to enter Light Delay Off mode. The light will be shut off

after 1 min.

To exit the Light Delay Off Mode, just tap the light key.

Within 30 seconds after power on,

press and hold Button & at the

same time for 5 seconds. LED indicator will flash .

When the pairing is done, it is shown that fan in LOW

and light is OFF.

12V

PAGE 1
OPERATION INSTRUCTION 1. Pairing: 1 Within 30 seconds after power on, press and hold Button & at the same time for 5 seconds. LED indicator will flash . ① ② ③ ④ When the pairing is done, it is shown that fan in LOW and light is OFF. ⑤ 2.Fan 3 speeds： Tap key ①/②/③（See Fig.1) to control fan high/medium/low speed. Front 3.Fan on/off ： Tap Fan on/off key(See Fig.1-④) to control fan on/off. 4.Light on/off: Tap light key (See Fig.1-⑤) to control lignt on/off . 2 5.
PAGE 2
INSTALL AND MAKE WIRE CONNECTION ANTENNA (LEAVE UNCONNECTED AND DO NOT CUT) HANGER BRACKET ANTENNA: DO NOT CUT OR SPLICE RECEIVER d e a b VIEW AF TE R INSTALLA TI ON 1 HANGER BALL c 2 1.) Make sure the electric power was turned off and then install the system. 2.) Ceiling fan must be set at HIGH speed and light kit (if any) at ON position by pulling the“Pull Switch”after installation. Once the connection has been made, the receiver inserts into the drop rod hanging bracket.