Honeywell 7.5ft 600ct Churchill Pine Slim Prelit User Manual Read and save these instruction before use W14L0689 CAUTION! ALWAYS UNPLUG YOUR TREE FROM ITS POWER SOURCE BEFORE ASSEMBLING OR DISASSEMBLING.
THANK YOU Thank you for purchasing The 7.5ft Honeywell Churchill Pine LED One Plug tree. This tree assembles in minutes and is decorated with LED light sets. For your convenience, it is equipped with a foot pedal switch for easy illumination. IMPORTANT SAFETY INSTRUCTIONS When using electrical products, basic precautions should always be followed including the following: READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Do not use this product outdoors.
PACKAGE CONTENT D Installation kit: A. Top Section B. Middle Section C. Bottom Section D. Tree Base C B (1 set) O E NE P A (1 piece) E. Screw (1 set) (1 set) (1 set) OTHER COMPONENTS G F F. Bolt G. Fuse H.
INSTALLATION Note: Before you start to assemble your tree, please choose a location near an electrical wall outlet. Place the tree stand on a level surface. Please remove protective covers from the base of the pole from each section. 1. Unfold the tree base to a 90 degree angle. 2. Carefully insert bottom section (C) of tree into tree base and tighten the screw (see Fig. 1). 3. Insert the middle section (B) of the tree into the bottom section (C) (see Fig. 2). 4.
TROUBLESHOOTHING If any lights do not work on your pre-lit tree, please check the following before calling customer service: 1. If entire tree or a section of the tree does not light: a) Make sure the end connector of the power cord is well connected to the bottom section (C). b) Check that each section of the tree is well connected. c) Check that there is power at the electrical outlet. d) Check fuses in tree’s plugs and replace if necessary (see Replace the fuse below). 2.
USER SERVICING INSTRUCTIONS (CONTINUED) ENN O PE P 3. Remove fuse carefully. 4. Risk of fire. Replace fuse only with 5 Amp, 125 Volt fuse (provided with product). 5. Close fuse cover. Slide closed the fuse access cover on top of attachment plug. 6. Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that should not be removed. Discard product if the attachment plug is damaged. B) Replace the fuse of the power cord from the bottom section ( C) and plug 2: 1.
USER SERVICING INSTRUCTIONS (CONTINUED) If the new lamp base does not fit in lampholder, follow the steps below before step 4: a) Pull the reflector out. b) Remove the base of burned out lamp by straightening lamp leads and gently pull lamp out. c) Thread leads of new lamp through holes in old base with one lead in each hole.
FCC STATEMENT (CONTINUED) NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
