Honeywell 9ft 800ct Eagle Peak Pine Prelit User Manual Read and save these instruction before use W14L0688 CAUTION! ALWAYS UNPLUG YOUR TREE SOURCE BEFORE ASSEMBLING OR DISASSEMBLING.
THANK YOU Thank you for purchasing The 9ft Honeywell Eagle Peak Pine LED One Plug tree. This tree assembles in minutes and is decorated with LED light sets. For your convenience, it is equipped with a foot pedal switch for easy illumination. IMPORTANT SAFETY INSTRUCTIONS When using electrical products, basic precautions should always be followed including the following: READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Do not use this product outdoors.
PACKAGE CONTENT C B A D O F NE P Installation kit: A. Top Section B. Upper Middle Section C. Lower Middle Section D. Bottom Section E E. Tree Base F. Screw (1 set) (1 set) (1 set) (1 piece) (1 set) (1 set) OTHER COMPONENTS H G J G.Bolt H.Reverse threaded iron bolt I. Retainer washer I K J. Fuse K.
INSTALLATION Note: Before you start to assemble your tree, please choose a location near an electrical wall outlet. Place the tree stand on a level surface. Please remove protective covers from the base of the pole from each section. 1. Unfold the tree base to a 90 degree angle. 2. Carefully insert bottom section (D) of tree into tree base and tighten the screw (see Fig. 1). 3. Insert the lower middle section (C) of the tree into the bottom section (D) (see Fig. 2). 4.
TROUBLESHOOTHING If any lights do not work on your pre-lit tree, please check the following before calling customer service: 1. If entire tree or a section of the tree does not light: a) Make sure the end connector of the power cord is well connected to the bottom section (D). b) Check that each section of the tree is well connected. c) Check that there is power at the electrical outlet. d) Check fuses in tree’s plugs and replace if necessary (see Replace the fuse below). 2.
USER SERVICING INSTRUCTIONS ENN O PE P Replace the fuse: A) Replace the fuse of extension cord with foot pedal switch (1 replaceable 5 A, 125 V fuse is located in the plug): Note: This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. 1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord. 2. Open fuse cover. Slide open fuse access cover on top of attachment plug towards blades. 3.
USER SERVICING INSTRUCTIONS (CONTINUED) CAUTION: 1. To reduce the risk of overheating, replace burned-out lamps promptly. Use 3.0 Volt, 0.06 Watt LED lamps only. The LED lamp has polarity. Do not deliberately change the direction of the LED lamp in the lamp holder. 2. Risk of fire. This product does not contain lamp shunts, which allow the product to operate if one lamp burns out. Replace lamps only with the spare lamps provided with this product.
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Please note that changes or modifications of this product is not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
