Product Info

TH1100DH: For 1 Heat systems
TH1110DH: For 1 Heat/1 Cool systems
TH1110E: For 1 Heat/1 Cool systems
*TH1110E model has a larger display than pictured
TH1210DH: For 2 Heat/1 Cool heat pump systems
Read before installing
Heat Off Cool
Auto On
Fan
Cool
On
*
PRO 1000 Series
Non-Progammable Thermostat
Product Information
Lo
Batt
Set
Cool
77
M32763
On
Quick reference to controls
Product manuals
Search online for Resideo 69-2607EFS for the User Guide.
Built-in compressor protection
Quick reference to display screen
Battery replacement
Adjust the temperature
CAUTION
Equipment damage hazard
To prevent possible compressor damage, do not operate cooling system
when outdoor temperature is below 50°F (10°C).
Low battery warning
Temperature
The ambient (measured)
temperature is normally
displayed. To view the
setpoint temperature, press
the Up or Down button once.
The setpoint temperature
will appear for five seconds.
System status
Cool on: Cooling system is on.
Heat on: Heating system is on.
Aux On: Auxiliary heat is on.
(Only for heat pumps with
this capability [select models
only].)
When “Heat On” or “Cool
On” is flashing, compressor
protection is engaged.
Setpoint indicator
Appears when the setpoint
temperature is displayed
Press s or t to adjust the
temperature.
Note: Make sure the thermostat
is set to the system you want to
control (heat or cool).
Set
Cool
77
M32769
On
This feature helps prevent damage to the
compressor in your air conditioning or heat
pump system.
Damage can occur if the compressor is restarted
too soon after shutdown. This feature forces the
compressor to wait 5 minutes before restarting.
During the wait time, the display will flash the
message Cool On. When the safe wait time has
elapsed, the message stops flashing and the
compressor turns on.
Message flashes until
safe restart time has
elapsed.
Install two fresh AAA batteries when Lo Batt
flashes on the screen. Lo Batt appears for
60 days before the batteries are depleted.
Replace batteries once a year, or when you
will be away for more than a month.
The settings are stored in non-volatile
(permanent) memory and are thus
preserved when the thermostat is without
batteries.
Pull at bottom to
remove thermostat
from wallplate.
Turn thermostat over, insert
fresh AAA alkaline batteries,
then reinstall thermostat.
Need Help?
For assistance please visit
Resideo.com
Electrical ratings
System Voltage (50/60Hz) Running Current
Heat (1st stage) 20-30 Vac 0.02-1.0 A
(Powerpile) 750 mV DC 100 mA DC
Auxiliary heat 20-30 Vac 0.02-1.0 A
Cooling 20-30 Vac 0.02-1.0 A
M32821
Auto On
Fan
Set
Cool
77
On
E.M. Heat Heat Off Cool
Up/Down buttons
Press to adjust temperature.
Fan Switch
On: Fan runs continuously.
Auto: Fan runs only when heating
or cooling system is on.
System switch
• Cool: Cooling system control.
• Off: All systems off.
• Heat: Heating system control.
• Em Heat: Emergency & Auxiliary Heat control. Compressor is locked
out. (Select models only.)
M32822
Set
Cool
77
On
E.M. Heat Heat Off Cool Auto On
Fan
W/
Aux
Not
Used
M32823
E.M. Heat Heat Off Cool Auto On
Fan
RTHXXXX
M32707
33-00529EFS-03