Honeywell Q607 AUXILIARY SWITCHES PROVIDE ADDITIONAL SWITCHING CAPABILITY FOR CONTROLLING AUXILIARY EQUIPMENT FROM A MODULATOR MOTOR. J Switches operate as a function of motor shaft position. 1Q607 mounts on either end of most Modulator motors. [1 Available with either 1 or 2 spit snap acting switches. [J Integral scale plate indicates motor shaft position. (7 Switches can be adjusted either on or off the motor, (3 Zine-plated steel case and cover. [1Q607C,D have terminal board and metric grounding screw.
noted below. TRADE LINE MODELS AVAILABLE: QB07A Auxiliary Switch~1 spit switch, OTB Auxiliary Switch~-2 PDT switches. TRADE LINE MODELS MSW Adeline models are selected and packaged to provide ease of stocking, ease of handling, and maximum replacement value, Trade line model specifications ave the same as those of standard models except as ACCESSORIES INCLUDED; 4074BPQ and T640JK bag assemblies.
MOUNTING The auxiliary switch cams may be adjusted before or after the QA is mounted on the motor; however, it is easier to adjust the switches before mounting. Refer to the Setting and Adjustments section for adjusting procedure; then complete the installation by mounting or wiring the Q607. 1. 2. accessories, 3 4. Make sure motor is in full closed position, Determine motor type and select Q607 mounting See Table I. Install adapter, H required, Fasten BUT bracket fo motor or adapter.
LOCK WASHERS (2) STUDS (23 LOCK WASHERS (2) 822 SCREWS (3) SELF TAPPING SCREWS (3). | brazen FIG. 4-MOUNTING GB ON MOTOR WITH EXPOSED SPRING-RETURN MECHANISM. WIRING All wiring must comply with local codes and ordinances, Do mot exceed the load rating of the switch contacts (see Specifications section).
Settings and adjustments for all QB models are basically the same, Each switch is adjusted separately by moving the operational cam and differential cam to the desired positions, The operational cam has 2 levels; as the cam roller moves between levels it makes one set of switch contacts and breaks the other. The differential cam also has 2 levels, but only one has any effect on switch operation.
(T) STARTING POSITION wren. ALIGN ZERO MARK ON DESIRED STALE WITH SLOT IN SCALE LOCK ADJUSTING SWITCH TO OVER 105 DEGREES + M405, M7022, M7024 SPRING RETURN MOTORS BUILT BEFORE 1966. (@ ser irrational CAR ALIGN DESIRED SWITCH MAKE POINT WITH SCALE LICK SLOT, TURN OPERATIONAL CAM UNTIL ROLLER I5 OF POINT OF UPPER CAH LOBE TENTH GENERATIONAL CAM SCREW. WITS; THIS PROCEDURE PREVENTS SWITCH REMAKE IF MOTOR OVERCOATS. ORLY. HRS DIFFERENTIAL RETWEET SWITCH MAKE AND BREAK POINTS 1S POSSIBLE.