HON-ST60 Wi-Fi Module Installation Instructions
Disclaimer Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made. The information in this publication does not represent a commitment on the part ofHII.
What You Get What You Need • A #T10 and a #T20 Torx screwdriver • A small Phillips screwdriver • A small wrench To install the 802.11 interface, you need to open the printer and physically install the interface board in the printer. This interface kit must only be installed by an authorized service technician. The device is country/region specific and must be ordered for the correct country/region.
Opening the Printer 1. Use a #T10 Torx screwdriver to remove the eight screws that secure the electronics cover. 2. Put the cover aside on a soft cloth to avoid scratches. 3. Insert the antenna cable into the antenna cable jack on the Wi-fi board. 4. Secure the antenna cable to the Wi-fi board with a cable tie. Note the location of the head of the cable tie. 5. Trim the excess from the cable tie. 6. Insert the Wi-fi board into the 44-pin connector.
7. Install the other end of the antenna cable on the back plate and tighten the nut. 8. Use the other cable tie to secure the antenna cable to the printer as shown. 9. Trim the excess from the cable tie. 10. Close the printer. 11. Connect the antenna to the antenna connector on the back plate.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Industry Canada statement: This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence.
Honeywell www.honeywellaidc.com Copyright © 2016 Honeywell International Inc. All rights reserved.