Installation Instructions

ManualsBrandsHoneywell ManualsElectronicsWire DUAL TEC Motion Sensor

- 1 -

DT8360CM / DT8360ACM DUAL TEC® Ceiling Mount Motion

Sensor

1. Select the Mounting Location

Mounting location guidelines:

• The range is obtained at a mounting height of 2.4m (8’) to 8m (26’). Max. detection range at 8m (26’) is Ø 21m (70’).

• Allow a clear line-of-sight to all areas to protect.

• Avoid mounting anything within 30cm (12”) in front of the sensor.

• Do not directly face windows.

• Avoid close proximity to moving machinery, fluorescent lights, and heating/cooling sources. Avoid use in turbulent air.

• Not for use in applications with pets.

2. Open the Sensor

1. Turn the arrow to point to the Unlock symbol.

2. Press firmly on housing latch.

3. Gently separate the front and rear housing.

Summary of content (7 pages)

PAGE 1
DT8360CM / DT8360ACM DUAL TEC® Ceiling Mount Motion Sensor Installation Instructions 1. Select the Mounting Location Mounting location guidelines: • The range is obtained at a mounting height of 2.4m (8’) to 8m (26’). Max. detection range at 8m (26’) is Ø 21m (70’). • Allow a clear line-of-sight to all areas to protect. • Avoid mounting anything within 30cm (12”) in front of the sensor. • Do not directly face windows.
PAGE 2
3. Mount the Sensor [A] = Fixed mounting holes [B] = Adjustable mounting slots from 61mm-85mm (2.4”-3.3”) [C] = Tamper hole *This accessory is not covered by the approval. 4. Wire the Sensor • • • Wiring Details Observe proper polarity. If not using the integrated EOL resistors, set all switches to OFF. If using the integrated EOL resistors: 1. Connect the sensor to the panel. 2. Set the appropriate Alarm, Tamper and Trouble/Anti-mask EOL DIP switches to ON. (see Step 5 ).
PAGE 3
5. Sensor Components and Settings 6. Walk Test the Sensor and Adjust as Needed 1. Close the sensor and apply power to the sensor. Initialization is complete when the LED stops flashing slowly (about 30 seconds). 2. Walk through the detection area and observe the LED. 3. Adjust the microwave range as necessary to meet installation requirements. Walk test mode is active for 15 minutes, then automatically exits test mode, disables the LED and enters normal operation mode.
PAGE 4
7. Detection Patterns Note: Attention detection beams go across access points such as windows, doors during sensor installation.
PAGE 5
8. Coverage Pattern Masking (DT8300-CPM) A set of 60° masks are provided for masking undesired areas. Attach the masks on the outside of the detector. With the supplied masks, you can mask 60°, 120°, 180° or 240°. Refer to the following examples: Note: To mask a certain area, attach the mask on the opposite side of the sensor, referring to the following examples.
PAGE 6
Depending on the Trouble condition, take the following corrective actions: • Verify the sensor is not blocked or masked. • Verify the power supply is sufficient (at least 9V at the sensor). • Cycle power to the sensor. REMOTE LED ENABLE (LED INPUT) (DT8360ACM only) The LED input terminal allows the LED to be remotely enabled. To use this feature, the LED DIP switch (switch 2) must be OFF, allowing the LED to operate based on the voltage level connected to the LED Input (see Wiring Details).
PAGE 7
APPROVAL/ LISTINGS • FCC part 15, Class B verified • IC ICES-003, Class B verified • UL 639 • ULC S306-03 • SIA-PIR-01 Passive Infrared detector standard features for false alarm immunity.