Portable Evaporative Air Cooler User Manual Read and save these instructions before use Model: CL70PE/CO70PE www.honeywellaircoolers.com E-mail: info@honeywellaircoolers.
PARTS DESCRIPTION 1 3 10 2 11 12 15 6 13 7 4 16 14 8 9 5 17 1) Control Panel 10) Plastic Net Filter 2) Handle 11) Rear Grill Screw 3) Louvers 12) Honeycomb Cooling Media 4) Water Level Indicator 13) Rear Grill 5) Casters 14) Water Regulator 6) Ice Compartment Lid 15) Water Fill Door 7) Power Cord Wrap 16) Water Inlet Valve 8) Water Tank 17) Drain Plug 9) Power Cord & Plug EN 1
USE & OPERATION CONTROL PANEL S C H M L 0.
USE & OPERATION (CONTINUED) FUNCTION BUTTONS POWER Press the POWER button to turn the unit on. The cooler will start automatically at medium speed. After a few seconds the speed will switch to low. To turn the unit off, press the button again. MODE Press the MODE button to activate evaporative cooling and/or louver swing modes. Press the MODE button until the “S” indicator light is illuminated on the control panel. The Vertical Louvers will begin to move left to right automatically.
USE & OPERATION (CONTINUED) ROOM COOLING AND HUMIDIFYING In cooling mode, Honeywell Air Coolers provide cool, moist air through the evaporation of water. There is a manual Water Regulator knob located behind the ice compartment of the unit. This allows you to adjust the amount of water pumped over the Honeycomb Cooling Media, thus helping to control cooling and humidification levels.
USE & OPERATION (CONTINUED) REMOTE CONTROL (CONTINUED) • • Exhausted batteries are to be removed from the product and safely disposed of as per local regulations. Do not dispose of batteries in fire. Batteries may explode or leak. WARNING: Caution for ingestion of the small battery. Keep away from children and animals. COOLER LOCATION Make sure to position the air cooler correctly before you set up and start using the product.
USE & OPERATION (CONTINUED) FILLING WITH WATER It is ideal to use the Continuous Water Supply Connection to run the unit for long periods of time without refilling the tank. This also helps prevent pump failure in case the cooler is running with inadequate water in the tank. CAUTION: Unplug the unit from the electrical power outlet before filling or emptying the water tank.
USE & OPERATION (CONTINUED) FILLING WITH WATER (CONTINUED) Manual Water Tank Refill: Open the Water Fill Door located on the side of the unit. The Water Level Indicator is located at the front of the unit. Refill the water tank when water level is low. Do not fill water above the "Max." water level mark to avoid water droplets collecting on the louvers. Check the water level in the tank before running the COOL function. Make sure that the water in the tank is above the minimum water level mark.
USE & OPERATION (CONTINUED) CLEANING & DRAINING THE WATER TANK If the cooler will not be used for a long period of time, please refer to the STORAGE & MAINTENANCE GUIDELINES located in the separate Safety & Maintenance Guide. WARNING: Before cleaning the unit, switch the unit OFF and disconnect from the electrical socket. • • • • Move the unit to a location where the water can be drained. Remove the cap from the Drain plug located at the bottom of the unit. Allow the tank to empty.
USE & OPERATION (CONTINUED) CLEANING THE PLASTIC NET FILTER* AND HONEYCOMB COOLING MEDIA • • • • • The appliance is supplied with a Plastic Net Filter* and Honeycomb Cooling Media. The Plastic Net Filter* and Honeycomb Cooling Media are located inside the Rear Grill. See Figure 1 for instructions on how to remove them from the unit for cleaning and maintenance. Do not run the unit in COOL mode with stale water in the tank.
JMATEK Limited Manulife Financial Centre, Kwun Tong, Hong Kong Phone: 852-2559-5522 Email: info@jmatek.com Web: www.jmatek.com Made in China © 2017 JMATEK Limited. All rights reserved. The Honeywell Trademark is used under license from Honeywell International Inc. Honeywell International Inc. makes no representations or warranties with respect to this product. This product is manufactured by Airtek Int'l Corp. Ltd. (subsidiary of JMATEK Ltd.).
