Portable Evaporative Air Cooler for Outdoor, Indoor & Commercial Use Enfriador de aire portátil por evaporación Ideal para Uso Externo, Interno y Comercial OWNER’S MANUAL Read and save these instructions before use MANUAL DEL USUARIO Lea y guarde estas instrucciones antes de usar Model: CO30XE Modelo: CO30XE Power rating: 288 Watts Potencia: 288W Voltage rating: 120 Volt AC, 60Hz Tensión: 120V~60Hz For product inquiries or support, visit www.honeywellaircoolers.
QUICK START GUIDE 1 Fill with water and plug into a standard power outlet. Note: Please make sure the household power voltage matches the product specifications. 2 3 Place near an open door or window. Note : Evaporative air cooler requires cross ventilation. Turn ON and enjoy the cooling breeze. Note: Start with LOW speed and gradually increase to higher speed for optimum cooling performance.
INDEX Read all instructions carefully before setting up and operating the unit, and please keep this instruction manual for future reference. This manual is designed to provide you with important information needed to setup, operate, maintain, and troubleshoot your cooler. Failure to follow these instructions may damage and/or impair its operation and void the warranty. SECTION 1. 2. 3. 4. 5. PAGE THANK YOU ..................................................................................................
THANK YOU Congratulations on your purchase of this versatile Honeywell Evaporative Air Cooler. For optimum cooling from your cooler, fill the water tank to maximum level and load ice inside the ice compartment before you turn on your air cooler. Cooler Location – Indoors (Important - Please Read!) Place the cooler in front of an open door or window. Ensure that there is adequate cross ventilation in the room by leaving a door or window open opposite the cooler.
USER TIPS Energy Efficient, No Compressor Honeywell Evaporative Air Coolers are built to maximize energy efficiency and keep costs low. Warm air is drawn into the cooler through the Honeycomb Cooling Media. Water pumped from the tank pours over the honeycomb media. As the warm air passes through the media, the water absorbs the heat, naturally cooling and humidifying the air. A fan propels the cooled air out into the room. This no-compressor system cools naturally, efficiently and inexpensively.
USER TIPS Indoor Use The recommended maximum relative humidity level is 60% or less, which allows a noticeable temperature decrease. The temperature decrease will be greater in drier climates because higher evaporation occurs when the humidity is low. The evaporative air cooler should not be used in enclosed spaces. It must be kept level and there must be water in the water tank. The room should have doors and windows opened to allow free air flow.
SAFETY RULES READ AND SAVE THESE INSTRUCTIONS: When using electrical appliances, basic safety precautions should always be followed: • Your cooler runs on 120 Volt AC, 60 Hz current. Check the household voltage to ensure it matches the appliance's rate specification. • Before operating the product remove it from its packaging and check that it is in good condition. • DO NOT operate any product with a damaged cord or plug. We recommend not using an extension cord with this appliance.
SAFETY RULES • DO NOT attempt to repair or adjust any electrical or mechanical functions of the cooler, as this may void the warranty. • DO NOT cover the air inlet or outlet on the appliance as this may cause motor damage. • DO NOT insert or allow objects to enter any ventilation or exhaust opening as this may damage the product and could cause electrical shock or fire. • DO NOT operate with the Honeycomb media removed as this will overload and damage the motor.
SAFETY RULES • Use Only on GFCI Protected Receptacles. • Power cords have to be contained. If they must run along the ground, make sure every inch of them is secured so they will not be tripped over. • The wiring and connections must be waterproof. Be sure the connections (to the air cooler) never get wet. Your unit is waterproof, but everything attached to it must be waterproof, too. • Set up your unit so it cannot be tripped over or wobble loose. It must rest on a solid support.
PARTS DESCRIPTION 10 1 13 18 9 2 3 4 11 16 15 14 5 8 12 1 2 3 4 5 6 7 8 9 Control Panel Handle Louvers Left Side Panel Water Tank Power Cord Power Plug Casters Ice Compartment Lid ACCESSORIES: Remote Control (2 AAA Batteries not included) 8 17 10 11 12 13 14 15 16 17 18 6 7 Back Grill Front Panel Water Level Indicator Remote Control Latch Right Side Panel Water Fill Door Drain Plug Water Regulator (under part 9)
USE & OPERATION CONTROL PANEL NATURAL Lighted Display Icons Low water level in tank Swing Cool Time delay set Speed Natural Low speed Medium speed High speed 9
USE & OPERATION FUNCTION BUTTONS POWER Press the button to turn the unit on. To turn the unit off, press the button again. The cooler will start automatically at medium speed. After a few seconds the speed will switch to low. SPEED Press the FAN or SPEED button repeatedly and the speed will change. The indicator light will show the selected speed. Low Speed Medium Speed High Speed SPEED COOL COOL To begin cooling the desired area press the COOL button.
USE & OPERATION SWING LOUVER MOVEMENT Press the SWING button. The indicator light will come on and the louvers will begin to move from right to left automatically. Manually adjust the horizontal louvers to change vertical airflow. NATURAL When the NATURAL button is pressed, the fan speed will change in between HIGH / MEDIUM / LOW / STOP to simulate a natural wind effect and will repeat the same cycle at every 24 seconds. When the NATURAL button is pressed, the symbol will illuminate in the display.
USE & OPERATION LOW WATER ALARM FUNCTION The unit is equipped with a low water sensor. When water in the tank is below the minimum level, you will hear 10 beeps and the COOL indicator light will flash continuously. At the same time the power to the pump inside the unit will be cut off to protect the life of the pump. To disengage the alarm function, turn off and unplug the unit from the power outlet, and fill the tank with water above the minimum level.
USE & OPERATION ROOM COOLING AND HUMIDIFYING When the Water Regulator is set to MIN, the water pump distributes a minimal amount of water to the Honeycomb Cooling Media. This results in less water evaporation and reduces the effect. When the Water Regulator is set to MAX, the water pump distributes the maximum amount of water to the Honeycomb Cooling Media. This results in maximum water evaporation and the cooling performance improves.
USE & OPERATION REMOTE CONTROL Power: Speed: Cool/Fan: Swing: Timer: Natural: On / Off Low / Medium / High Controls cooling or fan option Controls the motion of the louvers Controls timer function for automatic shut off When the NATURAL button is pressed, the fan speed will change in between HIGH / MEDIUM / LOW / STOP to simulate a natural wind effect and will repeat the same cycle at every 24 seconds. When the NATURAL button is pressed, the symbol will illuminate in the display.
USE & OPERATION CAUTION Unplug from power when refilling. Filling With Water Unplug the air cooler from power supply. Check water level indicator located on the front of the unit to determine the level of water inside the water tank. The water tank of this cooler holds up to 8 gallons of water. Be sure water in the tank is always above the minimum water level mark.
CLEANING & MAINTENANCE WARNING • Before cleaning the unit, switch it to the OFF position and remove the plug from the power socket. • To clean the outside, use a damp cloth to remove dirt and dust. • Never use corrosive elements or any chemicals to clean this product. • When the product is not in use, store the unit in a dry place out of direct sunlight. DRAINING AND CLEANING THE WATER TANK • Turn the power OFF and disconnect the air cooler from the power supply.
CLEANING & MAINTENANCE CLEANING THE HONEYCOMB COOLING MEDIA • The appliance is supplied with Honeycomb Cooling Media. • The Honeycomb Cooling Media is located inside the back panel. • • • • Open the back panel by using a star screw driver to clean or replace the Honeycomb Cooling Media. It is recommended that the Honeycomb Cooling Media be replaced every year, depending on use and environment.
TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE SOLUTION No discharge of air Cord is not plugged in. Make sure power cord is plugged in and the supply switch is on. Power is not on. Turn the unit ON by pressing button on the control panel. Pump is not turned ON. On Control Panel, turn COOL FUNCTION to ON. Low or no water in tank, when COOL is selected. Refill water tank. Damaged Pump or Calcium deposits on blower. Contact service center. When the Cooler is new.
TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE SOLUTION The unit does not respond Remote control batteries. Check batteries. Replace if needed. Try to operate using the control panel. Damaged Control Panel. Try activating with the Remote Control. If the unit responds, then it may be the Control Panel that is experiencing problems. Contact Customer Service Center. If neither Remote Control nor Control Panel works - contact Customer Service Center.
TECHNICAL SPECIFICATIONS MODEL NO. CO30XE 120V~ 60Hz 288 Watts 8 Gallons Honeycomb 18(W) x 13.9(D) x 33.7(H) inch 24.