Portable Evaporative Air Cooler User Manual Read and save these instructions before use Model: CL610PE / CL810PE www.honeywellaircomfort.com Email: info@jmatek.
CASTER WHEEL COVER INSTALLATION CL810PM / CO810PM / CL810PE / CO810PE Figure 1. Location of caster wheels after installing caster wheel covers. Caster wheel with brake Caster wheels Figure 2. Bottom View LB - Left Back Side, RB - Right Back Side, LF - Left Front Side, RF - Right Front Side Front RF LF RB LB Back Installation kits included: 1 2 x1 3 x2 5 4 x2 x4 x32 1. Body (caster wheels are pre-installed without caster wheel covers) X1 4. Caster Wheel Covers X4 2.
CASTER WHEEL COVER INSTALLATION CL810PM / CO810PM / CL810PE / CO810PE Step 1: Unscrew all 4 caster wheels Step 3: Step 2: Install the caster cover with caster wheel Step 4: 1 2 4 3 Assemble the 2 caster wheels (without lock) with LF & RF caster bracket Step 5: Tighten the 4 screws on each caster wheel Step 6: 1 2 4 3 Assemble the 2 caster wheels (with lock) with LB & RB caster bracket Tighten the 4 screws on each caster wheel
PARTS DESCRIPTION FOR MODEL: CL610PE/ CO610PE 5 1 2 6 9 3 14 10 7 4 11 13 8 12 FOR MODEL: CL810PE/ CO810PE 5 1 2 6 9 14 3 10 7 4 11 13 8 12 EN 1
PARTS DESCRIPTION (CONTINUED) 1) Control Panel 8) Casters 2) Lever for Horizontal Louvers 9) Rear Grill Screws 3) Louvers 10) Rear Grill 4) Water Level Indicator 11) Water Tank 5) Water Fill Door 12) Drain Plug 6) Handle 13) Water Inlet Valve 7) Side Grill 14) Power Cord & Plug WARNING -- READ AND SAVE THE AIR COOLER SAFETY & MAINTENANCE GUIDE AND USER MANUAL BEFORE USING THIS PRODUCT.
USE & OPERATION CONTROL PANEL 4 H 2 M SPEED SWING COOL TIMER 1 L POWER 0.5 SLEEP FUNCTION BUTTONS POWER Press the POWER button to turn the unit on. The cooler will start automatically at medium speed. After a few seconds the speed will switch to low. To turn the unit off, press the button again. SPEED Press the SPEED button repeatedly to change the speed between High (H) - Mid (M) - Low (L) Sleep (SLEEP).
USE & OPERATION (CONTINUED) REMOTE CONTROL ON/OFF POWER : ON / OFF SPEED : Low / Medium / High / Sleep MODE : Evaporative Cooling On / Off SWING : Controls the motion of the louvers TIMER : Controls the Timer function for automatic off MODE SWING TIMER SPEED NOTE: • • • • • • • • • • The remote control requires AAA (2 x 1.5V) batteries for replacement. Open the battery compartment at the back of the remote control and insert the batteries inside.
USE & OPERATION (CONTINUED) FILLING WITH WATER It is ideal to use the Continuous Water Supply Connection to run the unit for long periods of time without refilling the tank. This also helps prevent pump failure in case the cooler is running with inadequate water in the tank. CAUTION: Unplug the unit from the electrical power outlet before filling or emptying the water tank.
USE & OPERATION (CONTINUED) FILLING WITH WATER (CONTINUED) Note: The water capacity refers to the total volume of water that can be contained within the air cooler water tank and water distribution system. The water capacity in the tank at the “Max.” indicator level may be lower than the actual water capacity of the air cooler. WARNING: Do not fill water tank with dirty water or salt water. This can damage the unit and Honeycomb media. LOW WATER ALARM* The unit is equipped with a low water sensor.
USE & OPERATION (CONTINUED) CLEANING & DRAINING THE WATER TANK If the cooler will not be used for a long period of time, please refer to the STORAGE & MAINTENANCE GUIDELINES located in the separate Safety & Maintenance Guide. WARNING: Before cleaning the unit, switch the unit OFF and disconnect from the power outlet. • • • • Move the unit to a location where the water can be drained. Remove the cap from the Drain plug located at the bottom of the unit. Allow the tank to empty.
USE & OPERATION (CONTINUED) CLEANING THE HONEYCOMB COOLING MEDIA (CONTINUED) Removing the Honeycomb Cooling Media: 1. Remove the screws from the Rear Grill of the Air Cooler. 2. Carefully pull out the Rear Grill from the Air Cooler. 3. The Honeycomb Cooling Pad is secured on the Rear Grill by two Horizontal Bars that are fixed in place by two screws on the Left and Right Sides of these Horizontal Bars. Remove these screws to release the Horizontal Bars. 4.
Jmatek India Private Limited Unit No. 507, 5th Floor, Vipul Business Park, Sohna Road, Sector-48, Gurugram-122018, Haryana Website: www.jmatek.com email: info@jmatek.com Made in India © 2022 JMATEK Limited. All rights reserved. The Honeywell Trademark is used under license from Honeywell International Inc. Honeywell International Inc. makes no representations or warranties with respect to this product. This product is manufactured by Airtek Int'l Corp. Ltd. (subsidiary of JMATEK Ltd.).