Models 5203 / 5205 / 5207 / 5215 STEEL SECURITY SAFE WITH DIGITAL DIAL LOCK Read this manual carefully and never store it inside the safe!
Models 5203 / 5205 / 5207 / 5215 Steel Security Safe with Digital Dial Lock PACKAGE CONTENTS 1 – Steel Security Safe 1 – Operation Manual 2 – Entry Keys 2 – Override Access Keys 4 – “AA” Batteries 1 – Mounting Kit w/ Bolts ATTENTION DO NOT RETURN SAFE TO STORE! For missing parts or difficulty operating your safe, please contact our Consumer Assistance Department by telephone. Store will not accept returned products without prior authorization. You must first contact our consumer assistance department.
SETUP & OPERATION STEP 1. OPEN SAFE USING OVERRIDE KEY 1. Insert the Access Key into the lock and then remove the override key lock cover and insert the override key. 2. Turn the Override key counter clockwise to the left and turn the access key clockwise to the right and pull the door open. 3. While the door is open, return the Access key to the locked position and then turn and remove only the Override Key. Reinstall the override lock cover and safely store the key in a location away from the safe.
IF YOU FORGET PASSCODE If you forget your pass code, you can gain access to the safe by referring to the instructions outlined in Step 1- OPEN USING THE OVERRIDE KEY. Once the safe is opened, you can then reprogram a new pass code as outlined in Step 4 – PROGRAMMING A NEW PASSCODE. SETUP & OPERATION (Cont.) STEP 4. PROGRAMMING A NEW PASSCODE 1. With the door opened, locate the battery compartment cover and slide it to the right exposing the small reset button. (See diagram) 2.
REPLACING BATTERIES Upon activation, If the batteries in your safe are in need of replacement a small icon will appear on the LED display alerting you. If and when this icon appears, all 4 “A” batteries should be replaced immediately. If the batteries get too low on power, than access to the safe might require use of the override key to gain entry. Replacing the batteries is outlined in Step 2 INSTALL BATTERIES.
MOUNTING YOUR SAFE For extra security, you may want to permanently secure you safe to a back wall or floor. Pre-drilled holes for this purpose are located on the bottom and backside of the safe. While it is not extremely difficult to mount the safe, it is important that you have the proper tools and knowledge to do so. If not, then you might choose to utilize the services of a professional. MOUNTING (Models 5203 / 5205 / 5207) 1. 2. 3. 4. 5. 6.
MOUNTING (Model 5215) 1. 2. 3. 4. 5. 6. 7. 8. Unlock the safe and Pull the drawer out until it stops. On each of the drawer glides there is a small plastic latch. To remove the drawer you need to simultaneously push down on the right side latch while pulling up on the left side latch putting forward pressure on the drawer as you do. This will release the drawer from the drawer glides and allow the drawer to be removed.
LIMITED WARRANTY LH Licensed Products, Inc., (“LHLP, Inc.”) warrants that for a period of seven (7) years from the date of purchase, this product will be free from structural or mechanical defects resulting from materials or workmanship. LHLP, Inc., at its sole option and as the purchaser’s sole remedy under this warranty, will repair or replace this product or any component of the product found to be defective during the warranty period.
CONSUMER ASSISTANCE EMAIL (Best Contact LHLPCustomerService@LHLPinc.com Method): WEBSITE: www.Honeywellsafes.com (Effective April 15, 2013) ADDRESS: Consumer Assistance Dept. LH Licensed Products, Inc. 860 East Sandhill Avenue Carson, CA 90746 USA TELEPHONE: US/Canada 1-877-354-5457 (Toll Free) Mexico 01-800-288-2872 After English voice recording stops you must then enter 800-860-1677 to complete your call.
