Install Instructions

Table Of Contents

INSTALLATION INSTRUCTIONS

95-7484-01

Pneumatic

Thermostat and Humidistat Cover Kit

GENERAL

1. Determine whether thermostat is mounted vertically or

horizontally.

2. Determine whether cover requires a setpoint and ther-

mometer window or a blank window.

3. Select the appropriate window insert (Fig. 1).

4. Determine if a Setpoint Cover Insert is required. Gener-

ally, if the window is blank, the Setpoint Cover Insert is

required.

5. Follow the instructions in Installation Section to assem-

ble and mount the cover.

NOTE: Window Markings vary by kit number

Fig. 1. Windows

ASSEMBLY

1. Remove the caution card from the cover.

2. Peel the release liner from selected window back

CAUTION

To prevent damage to the window, carefully check

the window selection and orientation before

installing the window. Once assembled,

disassembly may damage the window.

3. Ensure that the window is oriented correctly for the

assembly. When viewed from the front of the cover, the

setpoint and day/auto openings are on the bottom for a

vertical cover or on the right for a horizontal cover. The

cover has slots which must mate with the mounting ears

on the backplate.

a. Insert the top edge of the window (Fig. 2) into the

slot in the top of the window hole

b. Bend the window slightly and pop the bottom edge

into the slot in the bottom of the window hole.

c. Press in place to secure window.

60 9070 80

HORIZONTAL WINDOWSVERTICAL WINDOWS

C6692

PAGE 1
Pneumatic Thermostat and Humidistat Cover Kit INSTALLATION INSTRUCTIONS GENERAL 1. 2. 3. 4. 5. Determine whether thermostat is mounted vertically or horizontally. Determine whether cover requires a setpoint and thermometer window or a blank window. Select the appropriate window insert (Fig. 1). Determine if a Setpoint Cover Insert is required. Generally, if the window is blank, the Setpoint Cover Insert is required. Follow the instructions in Installation Section to assemble and mount the cover.
PAGE 2
THERMOSTAT AND HUMIDISTAT COVER KIT 4. SETSCREW HOLES (4) (USE HOLES CLOSEST TO THE WALL) 60 70 60 70 80 80 90 If a Setpoint Cover Insert is required, assemble per Figure 3. WINDOW (DUAL SHOWN, PARTIALLY INSTALLED) SETPOINT SLOT 90 SETPOINT COVER INSERT C7256 M31318 Fig. 3. Setpoint cover insert Fig. 2.