Installation Guide

INSTALLATION INSTRUCTIONS
62-0286ES-01
Automation and Control Solutions
Honeywell International Inc. Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MN 55422 Toronto, Ontario M1V 4Z9
customer.honeywell.com
® U.S. Registered Trademark
© 2008 Honeywell International Inc.
62-0286ES—01 M.S. 07-08
50033847-001 SuitePRO™ Adaptor Plate
DRAFT 7/18/08 V2.1
PRODUCT DESCRIPTION
The 50033847-001 Adaptor Plate is used to attach a
SuitePRO™ thermostat to a 4 x 4 in. junction box or to a 2 x
4 in. junction box in the vertical position. Mounting screws are
supplied.
The adaptor plate may be used on all SuitePRO™ thermostat
models: TB6575A1000, TB6575B1000, and TB8575A1000.
NOTE: The adaptor plate is not needed when mounting a
SuitePRO™ thermostat horizontally on a 2 x 4 in.
junction box.
SPECIFICATIONS
Dimensions: Length 6 1/4 in. (158 mm), Width 5 1/16 in.
(128 mm), Depth 13/32 in. (10 mm)
Construction: Plastic
SuitePRO™ is a trademark of Honeywell International Inc.
INSTALLATION
Location
The thermostats are the temperature control element in a fan
coil or air-conditioning system. They must be located about
1.5m (5 ft.) above the floor in a position with good air
circulation to sense room temperature.
Mounting
The thermostat must be mounted flush to the wall. Mounting
screws are supplied.
For the mounting steps, refer to Fig. 1:
1. Feed the supply wires through the junction box and the
opening in the adaptor plate.
2. Affix the adaptor plate to the junction box using the
screws provided.
3. Refer to the TB6575/TB8575 SuitePRO™ Digital Fan
Coil Thermostats – Installation Guide (form 62-0278) for
installation of the thermostat.
4. Insert the adaptor plate’s screw head cover.
Fig. 1. Mounting the adaptor plate (50033847-001).
M27593
M27591
INSERT SCREW
TO LOCK MAIN
BODY TO
SUB-BASE
SNAP MAIN BODY
ONTO SUB-BASE
SUB-BASE
MOUNT ADAPTOR PLATE ONTO
4X4 WIRING BOX OR 2X4
VERTICAL JUNCTION BOX
USING TWO SCREWS
ADAPTOR
PLATE
SCREW HEAD
COVER
ADAPTOR
PLATE
MOUNT SUB-BASE
ONTO WALL PLATE
USING TWO SCREWS
NOTE: MIDDLE HOLES OF ADAPTOR PLATE ARE USED FOR MOUNTING
TO A 2X4 VERTICAL JUNCTION BOX. USE OUTER HOLES FOR
MOUNTING TO A 4X4 WIRING BOX.