User's Manual

Identifying the part

1. Power / Pairing Button

2. LED Indicator (Blue / Red)

3. Charging port

4. Micro-USB plug (No function)

5. Stereo plug

Pairing with cell phone

1. Make sure that the PAE Bluetooth Dongle is powered off ﬁrst.

3. Only release the Power/Pairing button when the LED is in Red/Blue alternate ﬂashing.

Note:

Note: The LED lights up and ashes in Blue before the Red/Blue alternate ashing, so please DO NOT release the

Power/Pairing Button in this status during pairing process until the Red/Blue alternate ashing occurs.

Connecting with PAE-300

Plug the Stereo plug and the Micro-USB

plug on the PAE Bluetooth Dongle all the

way into the Stereo port and Micro-USB

charger port on the PAE-300 respectively.

Red

Blue

2. Press and hold the Power/Pairing Button for approximate 8 seconds

until the LED ﬂashes in Red and Blue alternately. This means the PAE

Bluetooth Dongle is searching a device to pair.

1. Power On

When the PAE Bluetooth Dongle is off, press and hold the

Power/Pairing Button until Blue LED lights up and ﬂash

(approximate 5 seconds).

5sec.

2. Power Off

When the PAE Bluetooth Dongle is on, press and hold

the Power/Pairing Button until Red LED is on

(approximate 5 seconds) and then off.

5sec.

Basic operation

Bluetooth Dongle

User Manual

Personal Audio Enhancer

PAE-300

PAGE 1
Personal Audio Enhancer PAE-300 Bluetooth Dongle User Manual Connecting with PAE-300 Plug the Stereo plug and the Micro-USB plug on the PAE Bluetooth Dongle all the way into the Stereo port and Micro-USB charger port on the PAE-300 respectively. Basic operation 1. Power On When the PAE Bluetooth Dongle is off, press and hold the Power/Pairing Button until Blue LED lights up and ﬂash (approximate 5 seconds). 5sec. 2.
PAGE 2
Battery charge 4. From the cell phone setting menu, seek a Bluetooth device in pairing mode. Once “PAE Bluetooth Dongle” name is displayed, select it. 1. Plug a micro-USB cable (Optional) into the charging port on the PAE Bluetooth Dongle. 2. Connect the other side of micro-USB cable with a charger adaptor (Optional) with the output of 5V==1A (or 1000 mA) 3. Plug the charger adaptor into the wall socket to start charging. 5. If password is required by the cell phone, enter “0000” for the password. 6.
PAGE 3
Certification and Compliance FCC Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ----Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.