Storage Cabinet Instructions

ManualsBrandsHON ManualsFurniture10700 Series 36'' Wide 3 - Shelf Storage Cabinet

DOOR CABINET

Read all instructions and review illustrations

before installing.

Tools required for assembly:

Phillips screwdriver

Hardware pack includes:

(2) Door handle (4) Screw

Illustration 1

Door Handle Installation (refer to Illustration 1):

1. Fully open cabinet doors.

2. Locate pre-drilled holes along inside edge of

each door.

3. On the outside of one door, align holes in rear

of door handle with pre-drilled holes in door.

4. Use the Phillips screwdriver to install two

screws (from hardware pack) through pre-

drilled holes in door and into holes in rear of

door handle.

5. Repeat Steps 3 and 4 for remaining door.

Shelf Adjustment (refer to Illustration 2):

1. Fully open cabinet doors.

2. Using Phillips screwdriver, loosen shelf by turn-

ing shelf fasteners 1/2 turn counter-clockwise or

until loose.

3. Lift shelf off fastener pins and set aside.

4. Remove fastener pins from holes and insert at

desired position. Ensure all four pins are

installed at same height.

5. With notches down, position the shelf onto the

fastener pins. Ensure fastener pins are seated

into the shelf fasteners in bottom of adjustable

shelf.

6. Using Phillips screwdriver, tighten shelf by turn-

ing shelf fasteners 1/2 turn clockwise or until

fully locked on pins.

242-7128C

SIDE 1 OF 2 (4/04)

INSTALLATION

INSTRUCTIONS

Door

handle

Door

Pre-drilled

hole

Screw

Door handle

(shown Installed)

Illustration 2

Shelf fastener

Bottom of

shelf

Front of

cabinet

Summary of content (2 pages)

PAGE 1
DOOR CABINET Read all instructions and review illustrations before installing. Tools required for assembly: Phillips screwdriver Door Hardware pack includes: (2) Door handle (4) Screw Door Handle Installation (refer to Illustration 1): 1. Fully open cabinet doors. 2. Locate pre-drilled holes along inside edge of each door. 3. On the outside of one door, align holes in rear of door handle with pre-drilled holes in door. 4.
PAGE 2
DOOR CABINET Illustration 3 Side-To-Side Door Hinge Adjustment Instructions (refer to Illustration 3): Door cabinet 1. Fully open cabinet doors. 2. Locate door alignment screw on door hinge assembly. 3. Use the Phillips screwdriver to adjust door alignment screw. Door alignment screw 4. Turn door alignment screw clockwise to adjust door out or counterclockwise to adjust door in. Door Hinge Illustration 4 Front-To-Back Door Hinge Adjustment Instructions (refer to Illustration 4): Door cabinet 1.