Foxconn WFUR7 Foxconn WFUR7 Hardware Specification Rev. 0.
Foxconn WFUR7 Document Revision History Document Revision Date Modifier Comments 0.1 Dec. 30, 2013 Lin Eric Initial release 0.2 Feb.
Foxconn WFUR7 Contents 1. INTRODUCTION ............................................................................................ 4 1.1 Product Overview ............................................................................................. 4 1.2 Key Features ..................................................................................................... 4 2. ELECTRICAL SPECIFICATIONS.......................................................................... 5 2.1 Pin Definitions .............
Foxconn WFUR7 1. Introduction 1.1 Product Overview The Foxconn WFUR7 wireless LAN module contains the Realtak® RTL8188ETV single chip which is a highly integrated single‐chip 802.11n Wireless LAN (WLAN) network USB interface (USB 1.0/1.1/2.0 compliant) controller. It combines a WLAN MAC, a 1T1R capable WLAN baseband, and WLAN RF in a single chip. The RTL8188ETV provides a complete solution for a high throughput performance integrated wireless LAN device. It fully complies with IEEE 802.
Foxconn WFUR7 2. Electrical Specifications 2.1 Pin Definitions Table 3.1 Pin Definitions Pin # Name Pin # Name 15 GND 16 GND 13 GND 14 WPS 11 GND 12 GND 9 GND 10 GND 7 GND 8 HSDP 5 GND 6 HSDM 3 GND 4 +3.3V 1 PDn 2 +3.3V 2.2 Power Consumption Specifications Power consumption is measured using current probe loop on the Power rails of the USB interface (Pins). Table 3.
Foxconn WFUR7 3. RF Specification 3.1 TX Specifications (preliminary) Table 3.1 TX Specifications Data Rate (Mbps) Modulation Tx Typical Power (dBm) 1 DBPSK 16 2 DQPSK 5.5 Data Rate (Mbps) Modulation Tx Typical Power (dBm) HT20‐7.22 BPSK 14 16 HT20‐14.44 BPSK 14 CCK 16 HT20‐21.67 QPSK 14 11 CCK 16 HT20‐28.89 QPSK 14 6 OFDM 15 HT20‐43.33 16‐QAM 14 9 OFDM 15 HT20‐57.78 16‐QAM 14 12 OFDM 15 HT20‐65 64‐QAM 14 18 OFDM 15 HT20‐72.
Foxconn WFUR7 3.2 RX Specifications (preliminary) Table 3.2 RX Specifications (ANT 1 & ANT 2) Data Rate (Mbps) Modulation 1 Rx Sensitivity (dBm) Data Rate (Mbps) Max. Typ. DBPSK ‐83 ‐94 HT20‐7.22 2 DQPSK ‐80 ‐93 5.5 CCK ‐78 11 CCK 6 Rx Sensitivity (dBm) Modulation Max. Typ. BPSK ‐82 ‐87 HT20‐14.44 QPSK ‐79 ‐86 ‐91 HT20‐21.67 QPSK ‐77 ‐84 ‐76 ‐89 HT20‐28.89 16‐QAM ‐74 ‐82 OFDM ‐85 ‐88 HT20‐43.33 16‐QAM ‐70 ‐78 9 OFDM ‐84 ‐87 HT20‐57.
Foxconn WFUR7 3.3 Antenna Specifications Nominal antenna port impedance specification is 50 ohms for the Foxconn WFUR7 hardware. For regulatory requirements, it is assumed that the antenna gain is: Antenna gain for the 2.4GHz band : 1.22 dBi There are one antennas supporting 2.4‐2.5GHz band. The antenna will be defined ANT 1 where is listing below: Figure 3.
Foxconn WFUR7 4. Mechanical Specifications 4.1 Mechanical Drawing Figure 4.
Foxconn WFUR7 5. Environmental Specifications The following tables provide normal operating conditions and maximum rating requirements for WFUR7 hardware. Table 5.1 Operating Conditions (preliminary) Environment Limits Operating 0 ~ 60℃ ※The radio parts at operating state and above temperature of T‐shield. Table 5.2 Non‐operating Conditions (preliminary) Environment Non‐Operating Temperature Humidity Min. Typ. Max. Unit Min. Typ. Max.
Foxconn WFUR7 6. Part Numbering 6.1 ID Definitions Table 7.1 ID Definitions WLAN Type Realtek RTL8188ETV LAN 802.11n usb2.
Foxconn WFUR7 7.
Foxconn WFUR7 Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Foxconn WFUR7 Industry Canada Statement This device complies with Industry Canada license‐exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
Foxconn WFUR7 This device is intended only for OEM integrators under the following conditions: (1) The antenna must be installed such that 20 cm is maintained between the antenna and users, (2) The transmitter module may not be co‐located with any other transmitter or antenna. (3) The WA‐M‐LA‐02‐041 PIFA antenna with 1.22dBi gain was verified in the conformity testing.
