Foxconn WFU03 Series Foxconn WFU03 series f Hardware Specification 第 1 頁
Foxconn WFU03 Series Introduction Product Overview The Foxconn WFU03 series wireless LAN module contains the Ralink® MT7601 single chip which is a highly integrated MAC/BBP for 2.4GHz RF transmission and supporting 150Mbps PHY rate. It fully complies with IEEE 802.11 b/g/n feature rich wireless connectivity at high standards, delivers reliable, cost-effective, throughput from an extended distance.
Foxconn WFU03 Series Electrical Specifications Pin Definitions Table. Pin Definitions Pin # Name Pin # Name 51 N/A 52 +3.3V 49 N/A 50 GND 47 N/A 48 N/A 45 N/A 46 N/A 43 GND 44 LED_WLAN# 41 +3.3V 42 N/A 39 +3.
Foxconn WFU03 Series 2 Power Pins of the 5 exists in the Mini-Card spec, Max limit for each Pin is 500mA). For all MiniCard voltage rails (3.3V), it is recommended not to exceed 100mVpp noise in the frequency range of 10-500KHz. Table DC Specifications Parameters Symbol 3.3V Supply Voltage Conditions Min. - 3.0 +3.3V Typ. Max. 3.3 3.6 Unit V Receiver 3.3 V Current consumption Icc 33rx HT 40MHz MCS 7 200 mA 300 mA Transmitter 3.
Foxconn WFU03 Series Antenna Specifications Nominal antenna port impedance specification is 50 ohms for the Foxconn WFU03 series hardware. For regulatory requirements, it is assumed that the antenna gain is: Antenna gain for the 2.4GHz band : 2.5 dBi There are two antennas supporting 2.4-2.5GHz band. The Foxconn HD96017 connector will be used on the Foxconn WFU03 series hardware.
Foxconn WFU03 Series Environmental Specifications The following tables provide normal operating conditions and maximum rating requirements for WFU03 series hardware. Table . Operating Conditions (preliminary) Environment Limits Operating -10-70℃ ※The radio parts at operating state and above temperature of T-shield. Table . Non-operating Conditions (preliminary) Temperature Environment Humidity Min. Typ. Max. Unit Min. Typ. Max.
Foxconn WFU03 Series Module Photo Top side Bottom side 第 7 頁