October 26, 2017 CPWB-B450JBKZ PRODUCT SPECIFICATION CPWB-B450JBKZ B01-01 IEEE 802.11 b/g/n 1x1 AIOT Module Product Specification 1.0 Approved: Approved: Prepared by: ________________________ _________________________ _________________________ Zeke Wu Manager Matt Lin Supervisor Ben Ho Engineer FOXCONN CONFIDENTIAL 1 This preliminary specification is subject to change without notice. Copyright © 2016 Hon Hai Precision Ind Co., Ltd.
October 26, 2017 CPWB-B450JBKZ PRODUCT SPECIFICATION Revision History Date Number Approver Comments Dec. 18, 2016 1.0 Ben Ho Initial Draft Jan. 04, 2017 1.1 Ben Ho Adding information of Current consumption and Sensitivity Jan. 25, 2017 1.2 Ben Ho Adding information of Current consumption and Power consumption Mar. 31, 2017 1.3 Ben Ho Adding PCB layout, Placement, PCB specification, schematic, BOM, RF input and output characteristic Connector specification and reliability test item Oct.
CPWB-B450JBKZ PRODUCT SPECIFICATION October 26, 2017 All information contained in this document is the exclusive property of Foxconn Technology Inc. and its development partners. Any reproduction or disclosure of all or part of this document without the expressed written consent of Foxconn Technology Inc. is strictly prohibited. FOXCONN CONFIDENTIAL 3 This preliminary specification is subject to change without notice. Copyright © 2016 Hon Hai Precision Ind Co., Ltd.
CPWB-B450JBKZ PRODUCT SPECIFICATION October 26, 2017 TABLE OF CONTENTS Revision History .................................................................................................. 2 Table of Contents................................................................................................ 4 Chapter 1. Module Overview ............................................................................. 5 1-1 Key Characteristic ...........................................................................
CPWB-B450JBKZ PRODUCT SPECIFICATION CHAPTER 1. October 26, 2017 MODULE OVERVIEW The Foxconn B01-01 s a low profile, low power and high performance AIOT module. It is mainly consisted of Wireless IOT IC RTL8711AM, codec ALC5640 and 8MB flash for developing IOT application RTL8711AM is a highly integrated single-chip low power 802.11b/g/n Wireless LAN (WLAN) network controller. It combines an ARM-Cortex M3 MCU, WLAN MAC, a 1T1R capable WLAN based, and RF in a single chip.
October 26, 2017 CPWB-B450JBKZ PRODUCT SPECIFICATION 1-2 Pin Definition CN1 CN2 Figure 1 Pin Definitions (Module Top View) Table 1 CN1 Terminal for home appliance Pin Definitions Pin Number Symbol Name Type Pin Description 1 VCC POWER DC 5V 2 VCC POWER DC 5V 3 UART0_RTS I/O UART RTS (RTL8711AM GPIOA_3) 4 UART0_CTS I/O UART CTS (RTL8711AM GPIOA_5) 5 UART0_RX I/O UART RX (RTL8711AM GPIOA_6) 6 UART0_TX I/O UART TX (RTL8711AM GPIOA_7) 7 CHIP_EN I 8 NC NC NC 9 I2C3_SCL I
October 26, 2017 CPWB-B450JBKZ PRODUCT SPECIFICATION Table 2 CN2 Service UART terminal Pin Definitions Pin Number Symbol Name Type Pin Description 1 VCC POWER 2 DEBUG_UART_TX I/O Debug UART TX(RTL8711AM GPIOB_0) 3 DEBUG_UART_RX I/O Debug UART RX(RTL8711AM GPIOB_1) 4 GND GND Ground DC 3.3V FOXCONN CONFIDENTIAL 7 This preliminary specification is subject to change without notice. Copyright © 2016 Hon Hai Precision Ind Co., Ltd.
CPWB-B450JBKZ PRODUCT SPECIFICATION 1-3 October 26, 2017 PCB Specification Board-maker: Foxconn 宏華精密電子(煙台)有限公司 Material of the board: FR4 Model number: 1P-1173X00-40SB Board-thickness: 1.0mm (typ) Product-height: 5.45mm (max) Tolerance: 0.1mm Flame class: UL94V-0 FOXCONN CONFIDENTIAL 8 This preliminary specification is subject to change without notice. Copyright © 2016 Hon Hai Precision Ind Co., Ltd.
October 26, 2017 CPWB-B450JBKZ PRODUCT SPECIFICATION CHAPTER 2. 2-1 ELECTRICAL AND RF SPECIFICAITON Recommended Operation Rating Table 4 Operation Rating Parameter VCC RF Interface 2-2 Condition 3.3V Zo Min 4.5V Typ. 5V 50 Max. 5.5V Unit V Ohm Digital IO Pin DC Characteristic Table 5 Typical IO DC Parameter (3.3V) Symbol Parameter Conditions Min. Typ. Max Units VIH VIL VOH VOL VT+ VT+ IIL Input-High Voltage LVTTL 2 - - V Input-Low Voltage LVTTL - - 0.
October 26, 2017 CPWB-B450JBKZ PRODUCT SPECIFICATION 2-4 Power Consumption Table 8 Power Consumption Description IDLE (Disconnecting to AP) 130 Unit mW IDLE (Connecting to AP) 280 mW Maxmimun B mode CCK11M(18dBm) with Speaker play Voice 1125 mW 2G/1T- N mode HT 40MHz MCS 7 (13dBm) 2G/1T- N mode HT 20MHz MCS 7 (13dBm) 2G/1T- G mode OFDM54M (14dBm) 2G/1T- B mode CCK11M (16dBm) 890 880 930 1015 mW mW mW mW 2G/1R- N mode HT 40MHz MCS 7 (-60dBm) 2G/1R- N mode HT 20MHz MCS 7 (-60dBm) 2G/1R- G mode
October 26, 2017 CPWB-B450JBKZ PRODUCT SPECIFICATION 24 36 48 54 14 14 14 14 OFDM OFDM OFDM OFDM Tolerance:+/-2dBm 2-7 WiFi RF Specification – RX Table 10 IEEE 802.11 b/g/n RX Senusitivity Data Rate Modulation (Mbps) 1 2 5.5 11 6 9 12 18 24 36 48 54 DBPSK DQPSK CCK CCK OFDM OFDM OFDM OFDM OFDM OFDM OFDM OFDM Rx Sensitivity (dBm) Max. -83 -80 -79 -76 -85 -84 -82 -80 -77 -73 -69 -68 Typ. -95 -94 -90 -87 -92 -91 -88.5 -86.5 -83.5 -80.5 -76 -74.
CPWB-B450JBKZ PRODUCT SPECIFICATION 2-8 October 26, 2017 Antenna Specification Requirements Nominal antenna port impedance specification is 50 ohms for the Foxconn B01 hardware. For regulatory requirements, it is assumed that the antenna gain is: Antenna gain for the 2.4GHz band : 2.0dBi ANT FOXCONN CONFIDENTIAL 12 This preliminary specification is subject to change without notice. Copyright © 2016 Hon Hai Precision Ind Co., Ltd.
CPWB-B450JBKZ PRODUCT SPECIFICATION CHAPTER 3. 3-1 October 26, 2017 MECHANICAL SPECIFICATION Module Assembly Dimension FOXCONN CONFIDENTIAL 13 This preliminary specification is subject to change without notice. Copyright © 2016 Hon Hai Precision Ind Co., Ltd.
October 26, 2017 CPWB-B450JBKZ PRODUCT SPECIFICATION CHAPTER 4. 4-1 ADDITIONAL INFORMATION Module Photo Figure 2 Top Side Photo 4-2 Figure3 Bottom Side Photo Environment Specifications ˙Operating Conditions (preliminary) Operation Temperature : -10 ~ 80℃ Relevant Humidity: 5 ~ 95% (non-condensing) ˙Storage Conditions (preliminary) Non-Operation Temperature : -20 ~ 85℃ (Typ.
CPWB-B450JBKZ PRODUCT SPECIFICATION October 26, 2017 Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CPWB-B450JBKZ PRODUCT SPECIFICATION October 26, 2017 End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID: RX3-B01”. The grantee's FCC ID can be used only when all FCC compliance requirements are met.
October 26, 2017 CPWB-B450JBKZ PRODUCT SPECIFICATION Canada, Industry Canada (IC) Statement This Class B digital apparatus complies with Canadian ICES-003. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
October 26, 2017 CPWB-B450JBKZ PRODUCT SPECIFICATION Canada, Industrie Canada (IC ) Déclaration Cet appareil numérique de classe B est conforme à la norme NMB-003. Le présent appareil est conforme aux CNR d'Industrie Canada applicables auxappareils radio exempts de licence.
