QUICK GUIDE
GETTING STARTED Before using YoCam: Slide down I/O door latch F Insert Micro SD (TF) memory card Close I/O door and slide latch up to lock A E B G C A Power Button D E Mode Status Light B Wireless Button F Wireless Status Light C I/O Door G Camera Status Light D Shutter H I Camera status light will blink in PURPLE if no memory card is inserted. H Micro SD Card Slot I Micro USB Charging Port Accessories Guide Clip Mount Pendant Cord How to use: 1.
Powering On and Off To Power Off: To Power On: 1. Press and hold power button (A) for 3 seconds. 1. Press and hold power button (A) for 3 seconds. 2. After the beep, the mode status indicator is off 2. After the beep, the mode status indicator lights and the camera is off. up and the camera is on. Tips: Make sure YoCam is charged and microSD card is inserted before powering on Camera Modes 1. After turning on YoCam, check the mode status light (E) FIRST. 2. If it is RED, YoCam is in Video Mode.
Technical Specifications Lens Video Resolution Image Resolution Wireless Waterproof Battery Operating Temperature Fixed Focus / F2.0 Aperture / 140° wide angle 2.7K 30 fps / 1080P 60fps / 1080P 30fps / 720P120fps / 720P60fps / 720P30fps 8MP / 4MP Wide WiFi 802.11B/G/N / Bluetooth 4.0 IP68 (Up to 20 feet) 3.7V/700mAh built-in Li-ion Rechargeable Battery -5°C ~ 40°C Image/Video Stabilization Yes Image/Video HDR Yes Full user manual is available here: For more information, go to mofily.
FCC RF exposure information (SAR) This device meets the government's requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg.