INSTALLATION MANUAL J07H081 ThinkPad Bluetooth with Enhanced Data Rate
Contents SECTION ONE: 1.1 INTRODUCTION............................................................................................ 1 FEATURES .............................................................................................................................. 1 1.1.1 BLUETOOTH FUNCTION ............................................................................................................... 1 1.2 HARDWARE REQUIREMENTS .........................................................................
Section One: Introduction The Bluetooth Module use a monolithic single-chip, Broadcom BCM2045 and it can compliant Bluetooth 2.0.This Bluetooth module is base on the highly integrated BCM2045 stand-alone baseband processor with an integrated 2.4GHz transceiver. It is fully compliant with the Bluetooth radio specification and incorporates new modulation schemes to support enhanced data rate(EDR) of 3MBps. 1.1 Features 1.1.
of 3Mbps Pico Net 1 master to 7 slaves Operating Channels 79 channels of 1 MHz BW Security Full support of Bluetooth security provisions including hardware support for full length 128 bit encryption keys. Host Interface (USB) USB specification 2.0 compliant and using MDC reserve pin to communicate with Host Software Requirements Windows 98SE, ME, 2000, XP.
Section Two: Bluetooth Installation The following steps provide instructions for installing Bluetooth. 1. Make sure your Bluetooth device already insert into your notebook. 2. Make sure your notebook operating system support Windows 98SE or ME or 2000 or XP. 2.1 Bluetooth Installation Proceed to the following section. Double click the program “Setup.exe” to execute the setup procedure in the software package： 1.
2. Windows shows the welcome dialog as below, click the “Next” to begin the process： 3. The license agreement dialog will pop up, please read it carefully. If you agree it, choose “I accept the terms in the license agreement” and click “Next”： 4. Specify the destination folder in your local system, which you want the software install to.
You may use the default folder or click “Change” to install to different folder, then click “Next”： 5. The dialog “Ready to install the program” shows. Make sure the driver software is ready to be installed, click “Install”： 6.
7. Click “Finish” to exit the setup wizard： 8.
. After starting the Windows, you may check the Bluetooth Icon has show in your system：
. you could open the Windows “Device Manage” and check the Bluetooth device is running：
Section Three: FCC Notice 3.1 FCC Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: The transmitter module may not be co-located with any other transmitter or antenna. As long as conduction above is met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).
Appendix
