BCM92046 Manual 1
FCC/IC Warning Statement • • • • • • • Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
FCC/IC Warning Statement for Module • • • • • • • This device is intended only for OEM integrators under the following conditions: The antenna must be installed such that 20 cm is maintained between the antenna and users, and The transmitter module may not be co-located with any other transmitter or antenna, For all products market in US/Canada, OEM has to limit the operation channels in CH1 to CH79(2402~2480MHz) of Bluetooth for 2.4G band by supplied firmware programming tool.
NCC 警語 • 經型式認證合格之低功率射頻電機,非經許可,公司、商號或使 用者均不得擅自變更頻率、加大功率或變更原設計之特性及功 能。 • 低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發 現有干擾現象時,應立即停用,並改善至無干擾時方得繼續使 用。前項合法通信,指依電信法規定作業之無線電通信。低功率 射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機 設備之干擾。 • 本模組於取得認證後將依規定於模組本體標示審合格籤,並要求 平台上標示「本產品內含射頻模組:ID編號」 4
Product Specification Items Contents Bluetooth standard BT V2.1+EDR Modulation type FHSS, GFSK, π/4-DQPSK,8DPSK Number of channels Channel for USA ,Europe and most other countries as below: f=2402+k MHz ,k=0,1,2,3…..,78 Carrier frequency of each channel f=2402+k MHz ,k=0,1,2,3…..,78 Maximum output power to Antenna, power control value Bluetooth: 1.09dBm Power Rating (DC/AC, Volt rating) 3.3V+/-5% I/O Port or data cable if any USB2.0 Antenna Type, Gain and Connector Type Gain:2.
To execute ActivePerl 6
select it 7
Select it Click it 8
select it 9
select it 10
Select it 11
Select it 12
1.To execute BlueToolInstall (Version:V.0.8.7.
Choice that. Click it.
Click it.
Click it.
Click it 19
Click it 20
2. Driver in BTWUSB After inserting the bluetooth module, it will search driver of BTWUSB as below.
Then Select the Driver location and press “Next” 22
3.
Click HCI control in Transport to launch Bluetooth Module Select HCI control 27
Select USB 0 28
Choose 0-Vendor-specific Commands(0 key) 29
Click Set_TX_Carrier_Frequency_2045 for Transmitter Testing 30
Select frequency Select Carrier on Select Modulation Type Select Mode Select TX_Power_Level (We select 0dBm) 31
Click Write_Receive_Only for Receiving Testing 32
Select Frequency 33