ASSEMBLY INSTRUCTION 530C5-24 SPINDLE BACK 24"H COUNTER HEIGHT CHAIR Chair Back E Box Frame Wooden Seat m Front Leg (Left-Right) Y 1pc 1pe apes Side Stretcher (Long) Front Stretcher (Short) Jove Bolt 3] Coco Brit {Left-Right) M8 x 70mm M6 x 40mm apes 1pe apes PCs n Lock Washer Flat Washer Cs-Cb Screw Pan Head Screw #x1172" = = Dressmaker PCs PCs Bps Apes maiden Key m Glue M4 x 80mm 1pe 1pc This page lists all the contents included in the box.
Box Frame (B) onto Chair Back (A). Then insert Jumbo Bolt (G), Lock Washer (f) and Flat Washer (J) into prevailed holes of each corner by using Allen Key (M). Insert Job Bolt {H), Lock Washer (I} and Flat Washer (J) into the per-drilled holes of the middle of Chair Back (A} by using Allen Key (M}. Do not fully tighten the bolts in this step. Put the Chair Back {A), Box Frame (8) upside down on the soft and smooth surface.
Attach Front Leg (D) assembly to corner of Box Frame (B) along inserting the Front Stretcher (F) onto each hole on Front Leg (D} with applying some Glue (N}, then insert Jibe Bolt (G}, Lock Washer (1) and Flat Washer (J} using Allen Key (M), Insert Pan Head Screw (L} into the holes of Front Leg (D) and Stretcher (F) by using screwdriver {not included).
Attach Wooden Seat (C) and Box Frame (B) with Cs-Cb Screw (K) by using screwdriver {not included). Tighten all screws in this step. Turn the assembled chair to the upright position carefully. Make sure the chair is level,and then securely tighten all bolts at this stage.Assembly is now completed. Stand chair up on an even surface and check that it is balanced. If there is a slight wobble, apply downward pressure in the corner where a leg is uneven.