Installation Guide

ManualsBrandsHomeSullivan ManualsFurnitureDenim French Ladder Back Wood Counter Height Chair (Set of 2)

530C1-24 FRENCH LADDER BACK 24"H COUNTER HEIGHT CHAIR

ASSEMBLY INSTRUCTION

This page lists all the contents included in the box.

Please take the time to identify the hardware as

well as the individual components to this product.

As you unpack and prepare for assembly,place the

contents on a carpeted or padded area to protect

them from damage.

Chair Back

1pc

Box Frame

1pc

Wooden Seat

1pc

Front Leg (Left-Right)

2pcs

Stretcher

3pcs

Jcbc Bolt M6 x 70mm

Spring Washer M6 x 13mm

Flat Washer M6 x 16mm

2mm

Jcbc Bolt M6 x 40mm

8pcs 2pcs

10pcs

CBS Screw M4 x 25mm

Allen Key M4

6pcs

10pcs

CBS Screw M4 x 38mm

Glue

1pc

Summary of content (4 pages)

PAGE 1
ASSEMBLY INSTRUCTION 530C1-24 FRENCH LADDER BACK 24"H COUNTER HEIGHT CHAIR Box Frame Chair Back 1pc Wooden Seat 1pc 1pc Jcbc Bolt M6 x 70mm Stretcher 3pcs Flat Washer M6 x 16mm 2mm 10pcs 8pcs 2pcs CBS Screw M4 x 25mm 6pcs Jcbc Bolt M6 x 40mm CBS Screw M4 x 38mm 6pcs Front Leg (Left-Right) 2pcs Spring Washer M6 x 13mm 10pcs Allen Key M4 1pc Glue 1pc This page lists all the contents included in the box.
PAGE 2
Put the Chair Back (A) Box Frame (B) upside down on the soft and smooth surface.With assistance attach Box Frame (B) onto Chair Back (A).Then insert Jcbc Bolt (F),Spring Washer (H) and Flat Washer (I) into predrilled holes of each corner, by using Allen Key (L).Insert Jcbc Bolt (G),Spring Washer (H) and Flat Washer (I) into the predrilled holes of the middle of Chair Back (A),by using Allen Key (L).Do not fully tighten the bolts in this step.
PAGE 3
Attach Front Leg (D) assembly to corner of Box Frame (B) along inserting the Stretcher (E) onto each hole on Front Leg (D) with applying some Glue (M), then insert Jcbc Bolt (F), Spring Washer (H) and Flat Washer (I) using Allen Key (L). Insert CBS Screw (K) into the holes of Front Leg (D) and Stretcher (E) by using screw driver (not included).
PAGE 4
Attach Wooden Seat (C) and Box Frame (B) with CBS Screw (J) by using Screwdriver (not included).Tighten all wood screws in this step. Turn the assembled chair to the upright position carefully.Make sure the chair is level,and then securely tighten all bolts at this stage.Assembly is now completed. Stand chair up on an even surface and check that it is balanced. If there is a slight wobble, apply downward pressure in the corner where a leg is uneven. Keeping pressure in that corner, tighten all bolts.