How to Guide

88 5411 21

Cabin Creek

Coffee Table

IMPORTANT NOTE

Carefully remove all the parts from the carton and put

them individually on a soft cloth to prevent scratches

or other damages occuring to the parts.

We have taken great care in the design of this

product and request that you carefully and strictly

follow our assembly instructions to ensure a

completed product as it was designed.

Part List

Home Styles Consumer Assistance: www.homestyles-furniture.com,

servicedesk@homestyles-furniture.com, 888-680-7460, 877-831-0319

Stretcher

2 pcs.

Shelf

1 pc.

Side Frame

2 pcs.

Hardware List

Tools recommended for assembly : Level

Tools required for assembly : Phillips screwdriver

Head Cap Bolt

30 pcs. (+1 extra)

Spring Washer

30 pcs. (+1 extra)

Flat Washer

20 pcs. (+1 extra)

Big Flat Washer

10 pcs. (+1 extra)

Small

Hex Wrench

1 pc.

Hex Wrench

1 pc.

Cabinet

1 pc.

PAGE 1
88 5411 21 Cabin Creek Coffee Table IMPORTANT NOTE Carefully remove all the parts from the carton and put them individually on a soft cloth to prevent scratches or other damages occuring to the parts. We have taken great care in the design of this product and request that you carefully and strictly follow our assembly instructions to ensure a completed product as it was designed. Part List A. Cabinet 1 pc. B. Stretcher 2 pcs. C. Shelf 1 pc. C. Side Frame 2 pcs. Hardware List Head Cap Bolt 30 pcs.
PAGE 2
Assembly Instructions 2/3 IMPORTANT * Do not tighten up all the screws until each part is properly assembled. * You should keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future. * Use a soft cloth between these parts and the floor. * After assembly, item must be level to work properly. Use the included adjustable levelers to level.
PAGE 3
Assembly Instructions 3/3 A STEP 3 Remove the drawers, then place Cabinet (A) upside down on a soft cloth. Head Cap Bolt Spring Washer Big Flat Washer STEP 4 Attach unit onto Cabinet (A) with Head Cap Bolts, Spring Washers and Big Flat Washers. A STEP 5 Remove the Pull Handles that are installed on the inside of the drawers and re-install them on the outside of the drawers. (see Figure 3) Turn the unit over to its’ upright position. Slide the drawers into position.