Use and Care Manual

15 HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Operation (continued)
1
Powering the Fireplace
□ Push the Power button to supply power to all functions of
□ Push the Power button again to turn off all functions.
□ When the unit is in ON mode, the power icon indicator light
is green.
□ When the unit is in OFF mode, the power icon indicator light
is red. When the power is OFF, the unit stops working. If the
heater was operating before the power was turned OFF, the
fan will continue to run for 20 seconds to ensure there is no
heat trapped inside the unit.
NOTE: The unit has a memory function with last
unless the main power to the unit has been interrupted.
NOTE: When you plug in the unit each time, an internal
check program runs for 5 seconds before the fan and
heater turn on.
2
Adjusting the Temperature
3 4
□ The Heater button controls the heater’s thermostat
setting.
□ Press button to select the desired
temperature.
□ The thermostat setting range is 65°F (18°C) to 90°F (32°C),
ON & OF (OFF).
□ When the ambient temperature is higher than the set
temperature, heater will turn off automatically.
NOTE: Hold the Heater button for 3 seconds. This allows
the temperature unit to change from °C to °F or °F to °C.
The unit default is °F. This function is only available if
using the control panel.
Setting the Timer
□ The timer setting should be used to set the countdown for
the unit’s main power.
□ Press the button to adjust the timer setting cycle around
from 0 hour (OFF) to 9 hours with 1 hour interval.
Adjusting the Flame Brightness
□
□