Item #1006 325 683 Model # FHWA80088A USE AND CARE GUIDE STONEHAVEN LP FIRE PIT Questions, problems, missing parts? Before returning to the store, call Home Decorators Collection Customer Service. 8 a.m. - 7 p.m., EST, Monday - Friday, 9 a.m. - 6 p.m., EST, Saturday 1-800-986-3460 HOMEDEPOT.COM/HOMEDECORATORS THANK YOU quality products designed to enhance your home. Visit us online to see our full line of products available for your home improvement needs.
Table of Contents WARNING FOR YOUR SAFETY: For Outdoor Use Only (outside, non-enclosed area). Do Not Use For Cooking. Installation and service must be performed by a qualified installer, service agency, or the gas supplier. WARNING FOR YOUR SAFETY: If the information in this manual is not followed e y, a fire or e result causing property damage, personal injury or loss of life. WHAT TO DO IF YOU SMELL GAS: NOT try lighting any appliance.
Important Safety Information WARNING: Fire table is for outdoor use only. Installation and repair should be done by a qualified service person. The appliance should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required as necessary. It is imperative that the control compartment, burners and circulating air passageways of the appliance are kept clean.
Important Safety Information (continued) The use of alcohol, prescription or non-prescription drugs may impair an individual’s ability to properly assemble or safely operate this outdoor fire table. DO NOT use in an explosive atmosphere. Keep gas fire table area clear and free from combustible materials, such as gasoline. This outdoor fire table is not to be installed or used in or on recreational vehicles and/or boats. Always use in accordance with all applicable local, provincial and national codes.
Important Safety Information (continued) ATTENTION: Any alteration of the outdoor fire table that is not specifically directed in the operations manual will void manufacturer warranty. PROPANE (LP) DANGERS AND WARNINGS LP GAS LP gas is flammable and hazardous if handled improperly. Familiarize yourself with its hazards before using any LP gas product. PROPANE HAZARDS Flammable, explosive under pressure, heavier than air and settles in pools in low areas. In its natural state, propane has no odor.
Important Safety Information (continued) HOSE AND REGULATOR ASSEMBLY AND REPLACEMENT This fire table comes equipped with a standard LP gas hose and regulator including the appliance side connection for a CGA No. 791 Cylinder Connection Device. The LP gas hose and regulator supplied with this fire table must be used. Only a hose and regulator specified by manufacturer can be used for replacement. The CGA No.
Warranty 1 YEAR FRAME LIMITED WARRANTY WHAT IS COVERED We warrant the frames to be free of manufacturing defects to the original purchaser for one year. WHAT IS NOT COVERED It remains the customer’s responsibility for freight and packaging charges to and from our service center. This warranty does not cover s warranty. We reserve the right to make substitutions with similar merchandise, if the model in question is no longer in production. Contact the Customer Service Team at 1-800-986-3460 or visit www.
Pre-Assembly (continued) PACKAGE CONTENTS A K J L I B N P M O F C H G E D Q Part Description Quantity A Burner Lid 1 B Table Top 1 C Left Side Panel 1 D E Door Right Side Panel 1 1 F Middle Side Panel 1 G Tank Support 1 H I Limit Tube Glass Beads 2 1 J Burner Bowl 1 K Burner Ring 1 L M Pilot Housing Control Knob 1 1 N Manual Electric Igniter 1 O Regulator/Hose 1 P Q AAA Battery Knob 1 1 8 WARNING: Failure to position the parts in accordance with these d
Assembly 1 CONNECTING THE SIDE PANELS TO THE TABLE TOP Place the table top (B) upside down on a soft surface. Connect the left side panel and right side panel (C&E) to the table top (B) using M6X15 combination bolts (AA). Do not tighten the bolts at this step. NOTE: Pay attention to the direction of the control knob and ensure it is placed as shown. NOTE: Loosely tighten all the bolts using the hex wrench (GG). AA AA E B C 9 HOMEDEPOT.
Assembly (continued) 2 CONNECTING THE MIDDLE SIDE PANEL Connect the middle side panel (F) to the left side panel and right side panel (C&E) using M6x40 combination bolts (CC). Do not tighten the bolts at this step. NOTE: Loosely tighten all the bolts using the hex wrench (GG).
Assembly (continued) 3 CONNECTING THE LIMIT TUBES Connect the limit tubes (H) to the left side panel and right side panel (C&E) using M6X15 combination bolts (AA). Do not tighten the bolts at this step. NOTE: Loosely tighten all the bolts using the hex wrench (GG). AA E H C 11 HOMEDEPOT.
Assembly (continued) 4 CONNECTING THE TANK SUPPORT Connect the tank support (G) to the left side panel and right side panel (C&E) using M6x30 combination bolts (BB). Do not tighten the bolts at this step. NOTE: Loosely tighten all the bolts using the hex wrench (GG).
Assembly (continued) 5 CONNECTING THE DOOR Connect the door (D) to the left side panel (C) using M6x12 countersunk bolt (EE) and plastic washers (FF). Attach the knob (Q) to the door (D) using M4x30 bolt (DD) as show below. NOTE: Tighten all the bolts using hex wrench (GG) at this step. EE FF C Q D DD FF 13 HOMEDEPOT.
Assembly (continued) 6 CHECKING THE TABLE AND PLACE THE GLASS BEADS Once all of the bolts are in place, fully tighten all the bolts using the hex wrench (GG). Place the glass beads (I) into the square burner bowl (J). CAUTION: To ensure proper function, the screen on the pilot housing should be free of glass beads. WARNING: Surfaces on the fire table can remain extremely hot for a period after use. Allow 45 minutes to cool down before touching or moving the fire table.
Assembly (continued) 7 PLACING THE BURNER LID Place the burner lid (A) over the burner bowl (B). Make sure to remove the burner lid before lighting. Do not place the lid back onto burner bowl until it has cooled down. WARNING: Surfaces on the fire table can remain extremely hot for a period after use. Allow 45 minutes to cool down before touching or moving the fire table. A B 15 HOMEDEPOT.
Operation 1 INSTALLING LP GAS TANK . Loosen LP gas tank retainer bolt by turning counterclockwise. Place a precision-filled LP gas tank upright into hole in outdoor fireplace base so the tank valve is facing the gas line connection. Secure tank by turning LP gas tank retainer bolt clockwise until tight. CAUTION: LP gas tank must be properly disconnected and removed prior to moving this outdoor fireplace. Make sure LP gas tank valve is closed.
Operation (continued) 2 CONNECTING LP GAS TANK Before connecting, be sure there is no debris caught in the head of the LP gas tank, head of the regulator valve or in the head of the burner ports. Connect the regulator/hose assembly to the tank by turning the knob clockwise until it stops. 17 HOMEDEPOT.
Operation (continued) 3 DISCONNECTING LP GAS TANK Before disconnecting make sure the LP gas tank valve is “CLOSED”. Disconnect regulator/hose assembly from LP gas by turning the knob counterclockwise until it is loose. Place the protective cap cover on the LP gas tank and store it outdoors in a well-ventilated area out of direct sunlight. NOTE: LP gas tank must be properly disconnected and removed prior to moving this fire table.
Operation (continued) 4 CHECKING FOR LEAKS AND BURNER CONNECTIONS the “Important Safety Information” section on page 3 to 6. Failure to follow those instructions can lead to serious injury or property damage, or cause death. Make sure the regulator/hose and valve connections are securely fastened to the burner and the tank. Please refer to Figures 1 and 2 for proper installation.
Operation (continued) 5 TANK/GAS LINE CONNECTION LEAK TEST Make 2-3 oz. of leak detection solution by mixing one part liquid dishwashing soap with three parts water. Make sure the control knob is in the “OFF” position. Connect LP gas tank per “CONNECTING LP GAS TANK” SECTION. Turn LP gas tank valve to “OPEN”. Spoon several drops of solution, or use a squirt bottle, at all “X” locations (Figure 1 and 2 on the previous page).
Operation (continued) 6 INSERTING THE BATERRY Insert the AAA battery (P) into the manual electric igniter (N) and twist the button cover on to igniter housing. Do not over tighten. CAUTION: Do not put batteries into the fire or trash. Please treat batteries as hazardous waste and recycle properly. P 21 HOMEDEPOT.
Operation (continued) 7 CLOSING THE DOOR 22
Operation (continued) CAUTION: Failure to follow these instructions could cause a fire or an explosion which can cause death, serious bodily injury or damage to property. WARNING: CAUTION: Keep outdoor gas appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquid. CAUTION: CAUTION: LIGHTING 1. Make sure all labels, packaging and protective films have been removed from the outdoor fire table. 2.
Operation (continued) LIGHTING (CONTINUED) 11. If igniter does not light burner: a. Wearing heat-resistant gloves, position a long, lit match or long, lit butane lighter near the pilot housing. b. Push and turn control knob to “ON”. c. Remove match/lighter once burner is lit. 12. After lighting, observe the burner flame and make sure all burner ports are lit and flame height matches illustration on page 23.
Care And Maintenance Cleaning Surfaces 1. Wipe surfaces clean with mild dishwashing detergent or baking soda mixed with water. 2. For stubborn stains, use a citrus-based cleaner and a nylon scrubbing brush. 3. Rinse clean with water. 4. Allow to air dry. Before Storing 1. Turn LP gas tank valve to “CLOSED”. 2. Turn control knob to the “OFF” position. NOTE: A “poof” sound is normal as the last of the LP gas is burned. 3. Disconnect LP gas tank per “Disconnecting LP Gas Tank” section. 4. Clean all surfaces.
Troubleshooting The burner will not light using the igniter. The LP gas tank valve is closed. Make sure that the regulator is securely attached to the LP gas tank per the "Installing the Gas Tank" section. Then turn the LP gas tank valve to "OPEN." The LP gas tank is low or empty. Exchange, refill or replace LP gas tank. The LP gas leaks. 1. Turn LP gas tank valve to “CLOSED”. 2. Wait 5 minutes for gas to clear. 3. Follow “Checking for Leaks” section. The battery needs to be changed.
Troubleshooting (continued) The tank is out of gas. Exchange, refill or replace LP gas tank. 1. Turn control knob to “OFF”. There is a sudden is reduced. An irregular flame pattern flame does not run the full length of burner. Overfilling prevention device may have been activated. There is no gas flow. 3. If flames are still too low, reset the overfilling prevention device: a. Turn control knob to “OFF”. b. Turn LP gas tank valve to “CLOSED”. c. Disconnect regulator. d. Turn control knob to “ON”. e.
Questions, problems, missing parts? Before returning to the store, call Home Decorators Collection Customer Service. 8 a.m. - 7 p.m., EST, Monday - Friday, 9 a.m. - 6 p.m., EST, Saturday 1-800-986-3460 HOMEDEPOT.COM/HOMEDECORATORS Retain this manual for future use.
