Warranty
10
Club Chair Assembly (continued)
3
ATTACHING THE CHAIR SEAT TO THE CHAIR BASE
□ Place the Chair Seat (A) on a non-abrasive flat surface. Align the holes on the support bar on the underside of the
chair seat with the holes on the Spring Plates which are pre-attached to the chair base. Insert Bolts (GG) through
the Flat Washers (LL), C Clamp Plate (PP), Support Bar attached to the underside of the seat, and Spring Plates
attached to the U Support Bar (E) as the diagram shows.
□ Secure the bolts with Flat Washers (LL), Lock Washers (MM), and Nuts (NN). The support bar and spring plate
should be sandwiched in between the C Clamp Plates (PP). See figure.
□ Once all the Nuts (NN) and Bolts (GG) are in place, securely tighten all the Bolts (GG) and Nuts (NN) with the Hex
Wrench (QQ).
CAUTION: Improper assembly may result in serious personal injury.
E
LL
LL
MM
NN
PP
A
C
U Support
Bar
B
D
GG