Installation Guide

ManualsBrandsHolcam ManualsBathEclipse 60 in. W x 60.5 in. H Frameless Bypass Sliding Tub Door in Brushed Nickel

Table Of Contents

General Required Tools

* Pencil or water soluble felt pen

* Hacksaw with 24 tooth blade

* Metal file (smooth sharp edges)

* Tape measure

* Drill, electric or battery

* #2 Phillips Screw driver

* 3/16” Carbide drill bit for tile

* 1/4" Carbide drill bit for tile

* Caulking gun

* Clear 100% Silicone (recommended)

* 4 ft. Level

* Rubber mallet

* Razor knife

* Blue painters tape

Booklet: MM.5003

TRBSE

ECBSE

Shower Slider

TRBTE

ECBTE

Tub Slider

Pick a unit below that best represents your configuration.

IMPORTANT: Warnings and General Shower Door Information

Page 2

Thank you for purchasing this outstanding product!

This booklet will help you install your units safely and successfully.

SAFETY

WARNINGS:

GLASS FRAGILESHARPCAUTIONHEAVY

Scan this Barcode for Parts Bag BP.5003.NTL

Installation Instructions

Models: TRBTE / TRBSE

ECBTE / ECBSE

3/8" Frameless Slider

P/N MM.5003

rev061818

Summary of content (8 pages)

PAGE 1
Installation Instructions Models: TRBTE / TRBSE ECBTE / ECBSE 3/8" Frameless Slider P/N MM.5003 rev061818 Scan this Barcode for Parts Bag BP.5003.NTL Thank you for purchasing this outstanding product! This booklet will help you install your units safely and successfully. IMPORTANT: Warnings and General Shower Door Information Page 2 SAFETY WARNINGS: HEAVY CAUTION SHARP GLASS FRAGILE Pick a unit below that best represents your configuration.
PAGE 2
Page 2 SAFETY WARNINGS: HEAVY CAUTION SHARP GLASS FRAGILE CAUTION - READ THOROUGHLY BEFORE INSTALLATION Follow instructions: Instructions must be read and followed carefully to reduce the risk of serious injury during and after installation. Any deviation from these instructions can create safety hazards. Tempered Glass: Agalite enclosures glass panels are safety tempered to conform to general building codes. The intent of tempering is to reduce the risk of injury. Be careful handling tempered glass.
PAGE 3
Installation Instructions Page 3 Models: TRBTE / TRBSE ECBTE / ECBSE 3/8" Frameless Slider 7c 4 3 9 3 8a 5 4 10 7b 7b 8a 1 1 7c 2 8c 10 5 2 8c 18 17 8c 16 8c 15 Outside Sliding Panel Inside Sliding Panel (towards showerhead) 14 7d 14 10 11 13 6 12 7e Parts List HA.3102 HARDWARE PART BOX 1. 2. 3. 4. 5. 6. 7. HA.3001 - Roller Wheels ---------- 4 HA.3002 - Anti Jump Posts ------ 4 HA.3003 - Bumper Stops --------- 4 HA.3004 - Wall Collars ------------ 4 HA.
PAGE 4
Page 4 Installation Instructions Models: TRBTE / TRBSE ECBTE / ECBSE 3/8" Frameless Slider STEP 1 - Wall Plate Height Calculation: * Measure height of glass panels: ___________ * Subtract 3 11/16" from this measurement: ___________ * New measurement is the height from the threshold to the bottom of the First Wall Plate #5 in Step 3.
PAGE 5
Installation Instructions Page 5 Models: TRBTE / TRBSE ECBTE / ECBSE 3/8" Frameless Slider STEP 7 - Assemble Opposite Wall Plate and Tubes * Reference Detail E (upper) - Attach two Wall Pucks to the remainingWall Plate with the slots in a vertical position - Use two M6 X12mm Cap Screws and washers like in STEP 5 - Again, ensure cap screw does not extend through back Failure to do so could result in cracked tiles, etc. See Detail C - Attach Wall Collars onto the pucks.
PAGE 6
Page 6 Installation Instructions Models: TRBTE / TRBSE ECBTE / ECBSE 3/8" Frameless Slider STEP 10 - Install Sliding Panels: * Inside Sliding Panel: - Starting with Inside Panel (#17, showerhead wall), mount two Roller/Wheel l assemblies (#1) as shown Detail J. The flat Wheel face will face to the inside of the shower. - Adjust the Wheel so you have equal up and down adjustment. Tighten the Wheel securely as shown Detail K. - Repeat for second Wheel #1.
PAGE 7
Installation Instructions Page 7 Models: TRBTE / TRBSE ECBTE / ECBSE 3/8" Frameless Slider STEP 13 - Cut and Install Tub Jambs: reference diagram below * Measure / Cut Left Tub Jamb - Measure from the threshold to the bottom of the Wall Plate (5) on left wall. - NOTE: Threshold may be angled downward for drainage. This angle should be cut onto the bottom of the Tub Jamb. - Cut left Tub Jamb (10) to measured length.
PAGE 8
Installation Instructions Page 8 Models: TRBTE / TRBSE ECBTE / ECBSE 3/8" Frameless Slider STEP 16 - Install Black Screw Cover Vinyl: * Insert one length of VN.4303 vinyl (13), into center slot over to cover the screw heads and slot from top to bottom. * Snap in place by pushing vinyl towards the wall until it snaps into place, working your way down. * Work vinyl until it has a constant reveal. Cover Vinyl (13) STEP 17 - Installing Soft Sill #14: * Measure between the Center Guide #6 and a Tub Jamb.