U3 SET MANUAL MICROPHONE WIRELESS SYSTEM
This Class B digital apparatus complies with Canadian ICES-003. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN IC Caution: RSS-Gen Issue 4 December 2014"&"CNR-Gen 4e Décembre 2014: WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK: DO NOT REMOVE SCREWS. NO USER-SERVICEABLE PARTSINSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THE APPLIANCE TO RAIN OR MOISTURE. CERTIFICATION 210-119489 Radio Approvals: FCC Part 15.
FCC CERTIFICATION THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. WARNING: Changes or modifications not expressly approved in writing by Xvive may void the users authority to operate this equipment.
IMPORTANT SAFETY INSTRUCTIONS PLEASE READ THESE INSTRUCTIONS IN A SAFE PLACE WARNING: BEFORE USING YOUR XVIVE U3 MICROPHONE WIRELESS SYSTEM, CAREFULLY READ THE OPERATING INSTRUCTIONS. 1. Observe all instructions carefully in the U3 manual. 2. Do not to perform service operations beyond those described in the U3 manual.
U3 SET PRODUCT INTRODUCTION t (I[ CBOE JT PQUJNBM GPS EZOBNJD NJDSPQIPOF XJSFMFTT system, Approved for use in worldwide. t -FTT UIBO NT -BUFODZ 4JNVMUBOFPVT CSPBEDBTUT PO channels. t #SPBE )[ o ,)[ GSFRVFODZ SFTQPOTF t 6Q UP GFFU BDUVBM SBOHF EFQFOET PO 3' TJHOBM BCTPSQUJPO reflection and interference ) t )PVST PG CBUUFSZ MJGF SFDIBSHFBCMF CBUUFSZ GPS CPUI Transmitter & Receiver) t 8PSLT XJUI 9-3 EZOBNJD NJDSPQIPOF BOE CBUUFSZ QPXFSFE condenser microphones.
QUICK START 1. Plug the Transmitter into the XLR dynamic microphone and battery-powered condenser microphones. 05 2. Plug the Receiver into the Mixer.
QUICK START Hello! 3. Turn on the Transmitter and the SFDFJWFS BOE DIFDL UIF $IBOOFM 4. After connecting successfully, the LED lights on receiver will stay on. $IFDL UIF DPOOFDUJPO CZ UBMLJOH through the microphone.
BASIC OPERATION U3 TRANSMITTER .JD *O 9-3 NJDSPQIPOF JOQVU KBDL 2 Spring: Circumferential ground spring providing an accurate connection to the mating shell 1 2 .
BASIC OPERATION U3 RECEIVER 9-3 065 9-3 NJDSPQIPOF JOQVU KBDL 1 2 Power switch: switches the unit on and off 3 Channel status LED: indicates selected channel 4 Channel switch: selects Channels 1-6 5 USB Port: For charging the battery 6 RF Status LED: 0/ 5SBOTNJUUFS JT PO BOE MJOL JT FTUBCMJTIFE 2 Flashing = Signal connection interference 3 4 5 7 0'' 5SBOTNJUUFS Põ PS VOMJOLFE 7 Power status Led: indicates power status.
SPECIFICATIONS U3 MICROPHONE WIRELESS SYSTEM 09 Tuning Bandwidth o .)[ 8PSLJOH 3BOHF Up to 90ft. Actual Range Depends On Rf Signal Absorption, Reflection And Interference. Audio Frequency Response )[ o ,)[ E# %FQFOEFOU 0O .JDrophone Type Or Input Signal. Dynamic Range 110dB Battery Life Up To 5 Hours RF Sensitivity -88dBm Total Harmonic distortion 0.2% RF Output Power 10 mW E.I.R.P. max Operating Temperature Range -18ȭ to 57ȭ.
U3 TRANSMITTER U3 RECEIVER Dimensions 31 X 29 X 98 mm 31 X 29 X 98 mm Weight 93g 92g Housing Molded Plastic And Cast Metal Molded Plastic And Cast Metal Battery 3.7V Rechargeable Li-lon, 860mA 3.7V Rechargeable Li-lon, 860mA Impedance Input LƮ ,)[ 0VUQVU Ʈ ,)[ Audio Input Connector Balanced XLR Male Input Audio Output Connector Maximum Input Level Balanced XLR Female Output Mic Mode: 2.8Vp-p Line Mode: 7Vp-p Maximum Output Level 2.
BATTERIES AND CHARGING CHARGING TIMES BATTERY LIFE 0:15 30 min 0:30 1 hours 1:00 2 hours 2:30 5 hours * Always store U3 at room temperature 8IFO TUPSJOH UIF VOJU QMFBTF DIFDL UIF CBUUFSZ state regularly and charge if necessary. Connect Power $POOFDU UP UIF TPDLFU Note: Turn off the power switch while charging. Please do not use U3 when charging, which may reduce battery life.
2.4 GHz SPECTRUM OVERVIEW AND INTERFERENCE U3 operates within the 2.4GHz ISM band which is utilized by Wi-Fi, Bluetooth, and other wireless devices. 2.4GHz is an open band and, as such, does not require a license to be used worldwide. Tips and Methods to Improve Wireless System Performance 1) Keep more than 3 meteres distance between Receiver unit and other WiFi transmitters such as routers. 2) Change channels to avoid interference with other WiFi products.
TROUBLESHOOTING ISSUE SOLUTION t $IFDL UIBU UIF 6 3FDFJWFShT 3' -&% JT MJU t $IFDL UIBU UIF NJDSPQIPOF JT UVSOFE PO BOE SFDFJWJOH TJHOBM GSPN UIF 6 5SBOTNJUUFS No Sound t $IFDL UIBU UIF QPXFS TXJUDI JT UVSOFE PO GPS CPUI UIF 5SBOTNJUUFS BOE UIF 3FDFJWFS t &OTVSF UIBU UIF 6 5SBOTNJUUFS BOE 3FDFJWFS BSF PO UIF TBNF DIBOOFM t The Receiver can be paired with one Transmitter at a time. t "EKVTU UIF HBJO NPEF UP i-JOFw PS i.
APPLICATION SCENE Live Sound Mixers Dynamic Microphone Portable PA Systems DI Or XLR Output Gear U3 Receiver Recorders U3 Transmitter Mixer U3 SET DYNAMIC MICROPHONE WIRELESS SYSTEM "DUJWF -PVETQFBLFST 14
China Patent Numbers ZL 2016 3 0165464.8 2nd floor, Building 12, Xicheng Industrial Area, Xixiang Town, Baoan District, Shenzhen Guangdong China. 518101 E-mail: nancy@xviveaudio.