Instruction Manual

CA85 instruction manual

1. Charging input: Type-c port input: 5V-3A 9V-2A 12V-1.5A.

2. Output parameters: Place the phone on the car's output contact surface.

The car holder can output 5W/7.5W/10W/15W power to charge the

phone until the phone is fully charged.

3. LED indicator instructions: plug in the power supply, the green light

flashes, the green light flashes and then the standby blue light is always

on, the green light is always on when charging, the FOD foreign body

detection, the green light flashes quickly, and the output is turned off at

the same time.

NOTE: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions,may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on,

PAGE 1
CA85 instruction manual 1. Charging input: Type-c port input: 5V-3A 9V-2A 12V-1.5A. 2. Output parameters: Place the phone on the car's output contact surface. The car holder can output 5W/7.5W/10W/15W power to charge the phone until the phone is fully charged. 3.
PAGE 2
the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.