Installation Instructions

Note: this equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 and part 18 of the FCC Rules.
This equipment generates uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
ÿIncrease the separation between the equipment and any other radio device.
ÿConnect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
This device complies with part 15 and part 18 of the FCC Rules. Operation
is Subject To the following two conditions: (1)This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation. Changes or modifications not explicitly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.
The equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. During the operation of device a distance
of 15 cm surrounding the device and 20 cm above the top surface of the
device must be respected.
Caution: Any changes or modifications not expressly approved could void
the user's authority to operate the equipment.